In addition to 'active-low' and 'inactive-high-impedance' also
support 'active-high' property for PHY LED pin configuration.
As only either 'active-high' or 'active-low' can be set at the
same time, WARN and return an error in case both are set.
Signed-off-by: Daniel Golle <daniel@xxxxxxxxxxxxxx>
---
v2: emmit warning and return error if both, 'active-high' and
'active-low' are set
drivers/net/phy/phy_device.c | 6 ++++++
include/linux/phy.h | 5 +++--
2 files changed, 9 insertions(+), 2 deletions(-)
diff --git a/drivers/net/phy/phy_device.c b/drivers/net/phy/phy_device.c
index 4ccf504a8b2c..e92fac9aad92 100644
--- a/drivers/net/phy/phy_device.c
+++ b/drivers/net/phy/phy_device.c
@@ -3357,11 +3357,17 @@ static int of_phy_led(struct phy_device *phydev,
if (index > U8_MAX)
return -EINVAL;
+ if (of_property_read_bool(led, "active-high"))
+ set_bit(PHY_LED_ACTIVE_HIGH, &modes);
if (of_property_read_bool(led, "active-low"))
set_bit(PHY_LED_ACTIVE_LOW, &modes);
if (of_property_read_bool(led, "inactive-high-impedance"))
set_bit(PHY_LED_INACTIVE_HIGH_IMPEDANCE, &modes);
+ if (WARN_ON(modes & BIT(PHY_LED_ACTIVE_LOW) &&
+ modes & BIT(PHY_LED_ACTIVE_HIGH)))
+ return -EINVAL;
+
if (modes) {
/* Return error if asked to set polarity modes but not supported */
if (!phydev->drv->led_polarity_set)
diff --git a/include/linux/phy.h b/include/linux/phy.h
index ff762a3d8270..bf0eb4e5d35c 100644
--- a/include/linux/phy.h
+++ b/include/linux/phy.h
@@ -877,8 +877,9 @@ struct phy_plca_status {
/* Modes for PHY LED configuration */
enum phy_led_modes {
- PHY_LED_ACTIVE_LOW = 0,
- PHY_LED_INACTIVE_HIGH_IMPEDANCE = 1,
+ PHY_LED_ACTIVE_HIGH = 0,
+ PHY_LED_ACTIVE_LOW = 1,
+ PHY_LED_INACTIVE_HIGH_IMPEDANCE = 2,
/* keep it last */
__PHY_LED_MODES_NUM,
--
2.47.0
