On Fri, Sep 27, 2024 at 12:22:16PM +0800, Michael Wu wrote: > Since there are no registers controlling the hardware parameters > IC_CAP_LOADING and IC_CLK_FREQ_OPTIMIZATION, their values can only be > declared in the device tree. > > bus-capacitance-pf indicates the bus capacitance in picofarad (pF). It > affects the high and low pulse width of SCL line in high speed mode. The > only legal values for this property are 100 and 400, which are used to > calculate the tHIGH and tLOW periods for high speed mode. This property > corresponds to IC_CAP_LOADING. > > clk-freq-optimized indicates that the hardware input clock frequency is > reduced by reducing the internal latency. The property affects the high > period and low period of the SCL line. The property conrresponds to > IC_CLK_FREQ_OPTIMIZATION. > > Signed-off-by: Michael Wu <michael.wu@xxxxxxxxx> > --- > .../bindings/i2c/snps,designware-i2c.yaml | 14 ++++++++++++++ > 1 file changed, 14 insertions(+) > > diff --git a/Documentation/devicetree/bindings/i2c/snps,designware-i2c.yaml b/Documentation/devicetree/bindings/i2c/snps,designware-i2c.yaml > index 60035a787e5c..fc19e6a8b306 100644 > --- a/Documentation/devicetree/bindings/i2c/snps,designware-i2c.yaml > +++ b/Documentation/devicetree/bindings/i2c/snps,designware-i2c.yaml > @@ -87,6 +87,20 @@ properties: > This value is used to compute the tHIGH period. > default: 300 > > + bus-capacitance-pf: Why is this generic property? Is this going to be applied to all I2C controllers? If not, you miss vendors prefix. > + description: | > + This property represents the bus capacitance in picofarad (pF). It > + affects the high and low pulse width of SCL line in high speed mode. > + The only legal values for this property are 100 and 400, which are used > + to calculate the tHIGH and tLOW periods for high speed mode. > + default: 100 > + > + clk-freq-optimized: This was never tested. You got this comment already and not much improved. It does not look like you tested the bindings, at least after quick look. Please run (see Documentation/devicetree/bindings/writing-schema.rst for instructions). Maybe you need to update your dtschema and yamllint. > + description: | Do not need '|' unless you need to preserve formatting. Missing vendor prefix. Missing tests. Also, extend the example with this. > + If the hardware input clock frequency is reduced by reducing the > + internal latency, this property must be declared in the device tree. It > + affects the high period and low period of SCL line. I assume this is hardware choice, not driver? Best regards, Krzysztof
