It is used to configure controller parameters according to platform data, like speed, interrupt threshold, stream mode, etc. Signed-off-by: Peter Chen <peter.chen@xxxxxxxxxxxxx> --- drivers/usb/chipidea/ci.h | 2 ++ drivers/usb/chipidea/core.c | 57 +++++++++++++++++++++++++++++++-------------- drivers/usb/chipidea/host.c | 6 +---- 3 files changed, 43 insertions(+), 22 deletions(-) diff --git a/drivers/usb/chipidea/ci.h b/drivers/usb/chipidea/ci.h index aeec5f0..888606b 100644 --- a/drivers/usb/chipidea/ci.h +++ b/drivers/usb/chipidea/ci.h @@ -426,4 +426,6 @@ u8 hw_port_test_get(struct ci_hdrc *ci); int hw_wait_reg(struct ci_hdrc *ci, enum ci_hw_regs reg, u32 mask, u32 value, unsigned int timeout_ms); +void ci_platform_config(struct ci_hdrc *ci, int usb_mode); + #endif /* __DRIVERS_USB_CHIPIDEA_CI_H */ diff --git a/drivers/usb/chipidea/core.c b/drivers/usb/chipidea/core.c index 4d79392..f713e32 100644 --- a/drivers/usb/chipidea/core.c +++ b/drivers/usb/chipidea/core.c @@ -403,6 +403,44 @@ static int ci_usb_phy_init(struct ci_hdrc *ci) return ret; } + +/** + * ci_platform_config: do controller configure + * @ci: the controller + * @usb_mode: the usb mode + * + */ +void ci_platform_config(struct ci_hdrc *ci, int usb_mode) +{ + if (usb_mode == USBMODE_CM_DC) { + if (ci->platdata->flags & CI_HDRC_DISABLE_DEVICE_STREAMING) + hw_write(ci, OP_USBMODE, USBMODE_CI_SDIS, + USBMODE_CI_SDIS); + + /* + * Set interrupt interval for device mode + * host set ITC according to ehci-hcd module + * parameter log2_irq_thresh + */ + hw_write(ci, OP_USBCMD, 0xff0000, + ci->platdata->gadget_itc_setting << 16); + } else if (usb_mode == USBMODE_CM_HC) { + if (ci->platdata->flags & CI_HDRC_DISABLE_HOST_STREAMING) + hw_write(ci, OP_USBMODE, USBMODE_CI_SDIS, + USBMODE_CI_SDIS); + } else { + dev_warn(ci->dev, "USB mode in still not set\n"); + } + + if (ci->platdata->flags & CI_HDRC_FORCE_FULLSPEED) { + if (ci->hw_bank.lpm) + hw_write(ci, OP_DEVLC, DEVLC_PFSC, DEVLC_PFSC); + else + hw_write(ci, OP_PORTSC, PORTSC_PFSC, PORTSC_PFSC); + } + +} + /** * hw_controller_reset: do controller reset * @ci: the controller @@ -447,35 +485,20 @@ int hw_device_reset(struct ci_hdrc *ci) ci->platdata->notify_event(ci, CI_HDRC_CONTROLLER_RESET_EVENT); - if (ci->platdata->flags & CI_HDRC_DISABLE_DEVICE_STREAMING) - hw_write(ci, OP_USBMODE, USBMODE_CI_SDIS, USBMODE_CI_SDIS); - - if (ci->platdata->flags & CI_HDRC_FORCE_FULLSPEED) { - if (ci->hw_bank.lpm) - hw_write(ci, OP_DEVLC, DEVLC_PFSC, DEVLC_PFSC); - else - hw_write(ci, OP_PORTSC, PORTSC_PFSC, PORTSC_PFSC); - } - /* USBMODE should be configured step by step */ hw_write(ci, OP_USBMODE, USBMODE_CM, USBMODE_CM_IDLE); hw_write(ci, OP_USBMODE, USBMODE_CM, USBMODE_CM_DC); /* HW >= 2.3 */ hw_write(ci, OP_USBMODE, USBMODE_SLOM, USBMODE_SLOM); - /* - * Set interrupt interval for device mode - * host set ITC according to ehci-hcd module parameter log2_irq_thresh - */ - hw_write(ci, OP_USBCMD, 0xff0000, - ci->platdata->gadget_itc_setting << 16); - if (hw_read(ci, OP_USBMODE, USBMODE_CM) != USBMODE_CM_DC) { pr_err("cannot enter in %s device mode", ci_role(ci)->name); pr_err("lpm = %i", ci->hw_bank.lpm); return -ENODEV; } + ci_platform_config(ci, USBMODE_CM_DC); + return 0; } diff --git a/drivers/usb/chipidea/host.c b/drivers/usb/chipidea/host.c index b262c1c..c4f76b7 100644 --- a/drivers/usb/chipidea/host.c +++ b/drivers/usb/chipidea/host.c @@ -141,11 +141,7 @@ static int host_start(struct ci_hdrc *ci) } } - if (ci->platdata->flags & CI_HDRC_FORCE_FULLSPEED) - hw_write(ci, OP_PORTSC, PORTSC_PFSC, PORTSC_PFSC); - - if (ci->platdata->flags & CI_HDRC_DISABLE_HOST_STREAMING) - hw_write(ci, OP_USBMODE, USBMODE_CI_SDIS, USBMODE_CI_SDIS); + ci_platform_config(ci, USBMODE_CM_HC); return ret; -- 1.9.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html