On Fri, Sep 06, 2024 at 03:01:48PM +0530, Thippeswamy Havalige wrote:
> In the CPM5, controller-1 has platform-specific error interrupt bits
> located at different offsets compared to controller-0.
Technically mentions a difference between controller-0 and
controller-1, but doesn't say what the patch does.
> Signed-off-by: Thippeswamy Havalige <thippesw@xxxxxxx>
> ---
> drivers/pci/controller/pcie-xilinx-cpm.c | 39 +++++++++++++++++++-----
> 1 file changed, 32 insertions(+), 7 deletions(-)
>
> diff --git a/drivers/pci/controller/pcie-xilinx-cpm.c b/drivers/pci/controller/pcie-xilinx-cpm.c
> index a0f5e1d67b04..d672f620bc4c 100644
> --- a/drivers/pci/controller/pcie-xilinx-cpm.c
> +++ b/drivers/pci/controller/pcie-xilinx-cpm.c
> @@ -30,10 +30,13 @@
> #define XILINX_CPM_PCIE_REG_IDRN_MASK 0x00000E3C
> #define XILINX_CPM_PCIE_MISC_IR_STATUS 0x00000340
> #define XILINX_CPM_PCIE_MISC_IR_ENABLE 0x00000348
> -#define XILINX_CPM_PCIE_MISC_IR_LOCAL BIT(1)
> +#define XILINX_CPM_PCIE0_MISC_IR_LOCAL BIT(1)
> +#define XILINX_CPM_PCIE1_MISC_IR_LOCAL BIT(2)
>
> -#define XILINX_CPM_PCIE_IR_STATUS 0x000002A0
> -#define XILINX_CPM_PCIE_IR_ENABLE 0x000002A8
> +#define XILINX_CPM_PCIE0_IR_STATUS 0x000002A0
> +#define XILINX_CPM_PCIE1_IR_STATUS 0x000002B4
> +#define XILINX_CPM_PCIE0_IR_ENABLE 0x000002A8
> +#define XILINX_CPM_PCIE1_IR_ENABLE 0x000002BC
These are all indented with spaces; should use tabs like the other
definitions above.
> #define XILINX_CPM_PCIE_IR_LOCAL BIT(0)
Same here (although you didn't change this one).
> #define IMR(x) BIT(XILINX_PCIE_INTR_ ##x)
> @@ -280,10 +283,17 @@ static void xilinx_cpm_pcie_event_flow(struct irq_desc *desc)
> pcie_write(port, val, XILINX_CPM_PCIE_REG_IDR);
>
> if (port->variant->version == CPM5) {
> - val = readl_relaxed(port->cpm_base + XILINX_CPM_PCIE_IR_STATUS);
> + val = readl_relaxed(port->cpm_base + XILINX_CPM_PCIE0_IR_STATUS);
> if (val)
> writel_relaxed(val, port->cpm_base +
> - XILINX_CPM_PCIE_IR_STATUS);
> + XILINX_CPM_PCIE0_IR_STATUS);
> + }
> +
> + else if (port->variant->version == CPM5_HOST1) {
> + val = readl_relaxed(port->cpm_base + XILINX_CPM_PCIE1_IR_STATUS);
> + if (val)
> + writel_relaxed(val, port->cpm_base +
> + XILINX_CPM_PCIE1_IR_STATUS);
> }
When possible, I think it would be nicer to encode this difference in
the data, i.e., in struct xilinx_cpm_variant, than in the code. For
example,
struct xilinx_cpm_variant {
enum xilinx_cpm_version version;
+ u32 ir_status;
}
static const struct xilinx_cpm_variant cpm5_host = {
.version = CPM5,
+ .ir_status = XILINX_CPM_PCIE0_IR_STATUS,
};
static const struct xilinx_cpm_variant cpm5_host = {
.version = CPM5_HOST1,
+ .ir_status = XILINX_CPM_PCIE1_IR_STATUS,
};
Then this code could look like this, where it basically tests a
*feature* instead of checking for all the different variants:
struct xilinx_cpm_variant *variant = port->variant;
if (variant->ir_status) {
val = readl_relaxed(port->cpm_base + variant->ir_status);
if (val)
writel_relaxed(port->cpm_base + variant->ir_status);
}
(Apparently the CPM variant doesn't require this at all?)
> /*
> @@ -483,12 +493,19 @@ static void xilinx_cpm_pcie_init_port(struct xilinx_cpm_pcie *port)
> * XILINX_CPM_PCIE_MISC_IR_ENABLE register is mapped to
> * CPM SLCR block.
> */
> - writel(XILINX_CPM_PCIE_MISC_IR_LOCAL,
> + writel(XILINX_CPM_PCIE0_MISC_IR_LOCAL,
> port->cpm_base + XILINX_CPM_PCIE_MISC_IR_ENABLE);
>
> if (port->variant->version == CPM5) {
> writel(XILINX_CPM_PCIE_IR_LOCAL,
> - port->cpm_base + XILINX_CPM_PCIE_IR_ENABLE);
> + port->cpm_base + XILINX_CPM_PCIE0_IR_ENABLE);
> + }
> +
> + else if (port->variant->version == CPM5_HOST1) {
> + writel(XILINX_CPM_PCIE1_MISC_IR_LOCAL,
> + port->cpm_base + XILINX_CPM_PCIE_MISC_IR_ENABLE);
> + writel(XILINX_CPM_PCIE_IR_LOCAL,
> + port->cpm_base + XILINX_CPM_PCIE1_IR_ENABLE);
This looks questionable and worth a comment if this is what you
intend.
CPM
- sets PCIE0_MISC_IR_LOCAL in PCIE_MISC_IR_ENABLE
CPM5
- sets PCIE0_MISC_IR_LOCAL in PCIE_MISC_IR_ENABLE
- sets PCIE_IR_LOCAL in PCIE0_IR_ENABLE
CPM5_HOST1
- sets PCIE0_MISC_IR_LOCAL in PCIE_MISC_IR_ENABLE
- sets PCIE1_MISC_IR_LOCAL in PCIE_MISC_IR_ENABLE (overwrite)
- sets PCIE_IR_LOCAL in PCIE1_IR_ENABLE
The CPM5_HOST1 overwrite looks either wrong or like the first write
was unnecessary.
You might be able to simplify this by adding .misc_ir_value,
.ir_enable, and .ir_local_value:
struct xilinx_cpm_variant *variant = port->variant;
writel(variant->misc_ir_value,
port->cpm_base + XILINX_CPM_PCIE_MISC_IR_ENABLE);
if (variant->ir_enable)
writel(variant->ir_local_value, port->cpm_base + ir_enable);
> /* Enable the Bridge enable bit */
Unrelated to *this* patch except for being in the diff context, but
"enable the enable bit" is unclear because "enable" isn't something
you can do to a bit; you can *set* or *clear* a bit.
Bjorn
