Re: [PATCH 1/2] dt-bindings: hwmon: Introduce ADS71x8

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, 2 Sep 2024 13:24:59 +0000
"Sperling, Tobias" <Tobias.Sperling@xxxxxxxxxxx> wrote:

> > > > +  ti,mode:
> > > > +    $ref: /schemas/types.yaml#/definitions/uint8
> > > > +    description: |
> > > > +      Operation mode
> > > > +      Mode 0 - Manual mode. A channel is only sampled when the according  
> > input  
> > > > +        in the sysfs is read.
> > > > +      Mode 1 - Auto mode. All channels are automatically sampled  
> > sequentially.  
> > > > +        Reading an input returns the last valid sample. In this mode further
> > > > +        features like statistics and interrupts are available.
> > > > +    default: 0  
> > >
> > > I don't think this ti,mode property is suitable for bindings. sysfs is a
> > > linux implementation detail, when to do sampling is an implementation
> > > detail of your driver. Bindings are only supposed to describe properties
> > > of the hardware, not set software policy.  
> > 
> > Agreed. With an IIO driver this will become a switch based on what usespace
> > interfaces are enabled.
> > So if events are on or buffered data capture, enable automode.
> > If just sysfs reads, then manual mode is fine.  
> 
> Not quite sure if I understood you correctly. With the mode I intended to give
> control about the sampling behavior.
> In manual mode channels are only sampled if they are accessed/read.
> In auto mode they are sampled all the time sequentially. This also offers to use
> some extended features, like triggering an interrupt if a measurement crosses a
> defined limit.
> So the mode mainly affects the hardware behavior and just offers the possibility
> to catch that in userspace, if configured accordingly, but that's not a must-have.
> 
> Anyway, did I understood it correctly, that you suggest to configure the mode
> according some symbols in the kconfig and check that with #ifdef? Do you have
> the specific symbol names for me or a driver as example, so I can have a look?
No, this is not a build time of firmware config question. It is a question of
what the user is 'doing' with the device. Configure the mode according to what
userspace has enabled.

If it enables threshold detection, then turn on continuous mode.
If it enables capture of data via a chardev (so fast path) then turn on continuous
mode.  If neither of those, then run in manual mode.

Jonathan

> 
> Thanks and regards
> Tobias
> 





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux