Enable the USB-C port on FriendlyELEC NanoPC-T6. Works one way so far but still better than before. Signed-off-by: Marcin Juszkiewicz <marcin.juszkiewicz@xxxxxxxxxx> --- arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi | 76 ++++++++++++++++++++-- 1 file changed, 72 insertions(+), 4 deletions(-) diff --git a/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi b/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi index d172a8547a55..1e9a3be23ea9 100644 --- a/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi +++ b/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi @@ -137,6 +137,8 @@ vbus5v0_typec: vbus5v0-typec-regulator { gpio = <&gpio1 RK_PD2 GPIO_ACTIVE_HIGH>; pinctrl-names = "default"; pinctrl-0 = <&typec5v_pwren>; + regulator-always-on; + regulator-boot-on; regulator-name = "vbus5v0_typec"; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; @@ -381,11 +383,34 @@ connector { compatible = "usb-c-connector"; data-role = "dual"; label = "USB-C"; - power-role = "dual"; - try-power-role = "sink"; + power-role = "source"; source-pdos = <PDO_FIXED(5000, 2000, PDO_FIXED_USB_COMM)>; - sink-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>; - op-sink-microwatt = <1000000>; + + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + usbc0_hs: endpoint { + remote-endpoint = <&usb_host0_xhci_drd_sw>; + }; + }; + + port@1 { + reg = <1>; + usbc0_ss: endpoint { + remote-endpoint = <&usbdp_phy0_typec_ss>; + }; + }; + + port@2 { + reg = <2>; + usbc0_sbu: endpoint { + remote-endpoint = <&usbdp_phy0_typec_sbu>; + }; + }; + }; }; }; @@ -928,6 +953,14 @@ &uart2 { status = "okay"; }; +&u2phy0 { + status = "okay"; +}; + +&u2phy0_otg { + status = "okay"; +}; + &u2phy2_host { status = "okay"; }; @@ -944,6 +977,29 @@ &u2phy3 { status = "okay"; }; +&usbdp_phy0 { + mode-switch; + orientation-switch; + sbu1-dc-gpios = <&gpio4 RK_PA6 GPIO_ACTIVE_HIGH>; + sbu2-dc-gpios = <&gpio4 RK_PA7 GPIO_ACTIVE_HIGH>; + status = "okay"; + + port { + #address-cells = <1>; + #size-cells = <0>; + + usbdp_phy0_typec_ss: endpoint@0 { + reg = <0>; + remote-endpoint = <&usbc0_ss>; + }; + + usbdp_phy0_typec_sbu: endpoint@1 { + reg = <1>; + remote-endpoint = <&usbc0_sbu>; + }; + }; +}; + &usb_host0_ehci { status = "okay"; }; @@ -952,6 +1008,18 @@ &usb_host0_ohci { status = "okay"; }; +&usb_host0_xhci { + dr_mode = "host"; + status = "okay"; + usb-role-switch; + + port { + usb_host0_xhci_drd_sw: endpoint { + remote-endpoint = <&usbc0_hs>; + }; + }; +}; + &usb_host1_ehci { status = "okay"; }; -- 2.46.0