On 8/27/2024 3:31 PM, Rob Herring (Arm) wrote:
On Tue, 27 Aug 2024 11:48:15 +0300, Ciprian Costea wrote:
From: Ciprian Marian Costea <ciprianmarian.costea@xxxxxxxxxxx>
Adding 100mhz & 200mhz pinmux support for uSDHC helps to support
higher speed modes for SD (SDR50, DDR50, SDR104) and
eMMC (such as HS200, HS400/HS400ES).
Signed-off-by: Ciprian Marian Costea <ciprianmarian.costea@xxxxxxxxxxx>
---
arch/arm64/boot/dts/freescale/s32g2.dtsi | 153 ++++++++++++++++++
.../arm64/boot/dts/freescale/s32g274a-evb.dts | 4 +
.../boot/dts/freescale/s32g274a-rdb2.dts | 4 +
arch/arm64/boot/dts/freescale/s32g3.dtsi | 153 ++++++++++++++++++
.../boot/dts/freescale/s32g399a-rdb3.dts | 4 +
5 files changed, 318 insertions(+)
My bot found new DTB warnings on the .dts files added or changed in this
series.
Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.
If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:
pip3 install dtschema --upgrade
New warnings running 'make CHECK_DTBS=y freescale/s32g274a-evb.dtb freescale/s32g274a-rdb2.dtb freescale/s32g399a-rdb3.dtb' for 20240827084815.1931169-1-ciprianmarian.costea@xxxxxxxxxxx:
arch/arm64/boot/dts/freescale/s32g274a-rdb2.dtb: pinctrl@4009c240: 'usdhc0-100mhzgrp', 'usdhc0-200mhzgrp', 'usdhc0grp' do not match any of the regexes: '-pins$', 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/pinctrl/nxp,s32g2-siul2-pinctrl.yaml#
arch/arm64/boot/dts/freescale/s32g274a-evb.dtb: pinctrl@4009c240: 'usdhc0-100mhzgrp', 'usdhc0-200mhzgrp', 'usdhc0grp' do not match any of the regexes: '-pins$', 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/pinctrl/nxp,s32g2-siul2-pinctrl.yaml#
arch/arm64/boot/dts/freescale/s32g399a-rdb3.dtb: pinctrl@4009c240: 'usdhc0-100mhzgrp', 'usdhc0-200mhzgrp', 'usdhc0grp' do not match any of the regexes: '-pins$', 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/pinctrl/nxp,s32g2-siul2-pinctrl.yaml#
Hello Rob,
Thanks for pointing out these warnings.
I will fix them in V2.
Best Regards,
Ciprian Costea
