Hi Fabio, Currently, the Ethernet cable is not connected, which is why it's showing that message. If I connect the Ethernet cable, it will give a log like this: [ 12.670384] fec 30be0000.ethernet eth0: Link is Down [ 14.719222] fec 30be0000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx Regards, Tarang ________________________________________ From: Fabio Estevam <festevam@xxxxxxxxx> Sent: Tuesday, August 27, 2024 5:40 PM To: Tarang Raval <tarang.raval@xxxxxxxxxxxxxxxxx> Cc: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx>; shawnguo@xxxxxxxxxx <shawnguo@xxxxxxxxxx>; krzk+dt@xxxxxxxxxx <krzk+dt@xxxxxxxxxx>; Rob Herring <robh@xxxxxxxxxx>; Conor Dooley <conor+dt@xxxxxxxxxx>; devicetree@xxxxxxxxxxxxxxx <devicetree@xxxxxxxxxxxxxxx>; Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>; linux-kernel@xxxxxxxxxxxxxxx <linux-kernel@xxxxxxxxxxxxxxx>; Pengutronix Kernel Team <kernel@xxxxxxxxxxxxxx>; imx@xxxxxxxxxxxxxxx <imx@xxxxxxxxxxxxxxx>; linux-arm-kernel@xxxxxxxxxxxxxxxxxxx <linux-arm-kernel@xxxxxxxxxxxxxxxxxxx> Subject: Re: [PATCH v3] arm64: dts: imx8mm-emtop-baseboard: Add Peripherals Support CAUTION: This email originated from outside the organization. Do not click links or open attachments unless you recognize the sender and know the content is safe. Hi Tarang, On Tue, Aug 27, 2024 at 8:16 AM Tarang Raval <tarang.raval@xxxxxxxxxxxxxxxxx> wrote: > [ 8.639860] fec 30be0000.ethernet eth0: Unable to connect to phy > [ 8.708452] fec 30be0000.ethernet eth0: Unable to connect to phy What about this network issue?
