From: Konrad Dybcio <quic_kdybcio@xxxxxxxxxxx> GENI SE2 within QUP0 is used as UART on some devices, describe it. Signed-off-by: Konrad Dybcio <quic_kdybcio@xxxxxxxxxxx> --- arch/arm64/boot/dts/qcom/x1e80100.dtsi | 52 ++++++++++++++++++++++++++++++++++ 1 file changed, 52 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/x1e80100.dtsi b/arch/arm64/boot/dts/qcom/x1e80100.dtsi index 326283822aee..a2a011702752 100644 --- a/arch/arm64/boot/dts/qcom/x1e80100.dtsi +++ b/arch/arm64/boot/dts/qcom/x1e80100.dtsi @@ -2142,6 +2142,28 @@ &config_noc SLAVE_QUP_0 QCOM_ICC_TAG_ALWAYS>, status = "disabled"; }; + uart2: serial@b88000 { + compatible = "qcom,geni-uart"; + reg = <0 0x00b88000 0 0x4000>; + + interrupts = <GIC_SPI 584 IRQ_TYPE_LEVEL_HIGH>; + + clocks = <&gcc GCC_QUPV3_WRAP0_S2_CLK>; + clock-names = "se"; + + interconnects = <&clk_virt MASTER_QUP_CORE_0 QCOM_ICC_TAG_ALWAYS + &clk_virt SLAVE_QUP_CORE_0 QCOM_ICC_TAG_ALWAYS>, + <&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ALWAYS + &config_noc SLAVE_QUP_0 QCOM_ICC_TAG_ALWAYS>; + interconnect-names = "qup-core", + "qup-config"; + + pinctrl-0 = <&qup_uart2_default>; + pinctrl-names = "default"; + + status = "disabled"; + }; + spi2: spi@b88000 { compatible = "qcom,geni-spi"; reg = <0 0x00b88000 0 0x4000>; @@ -5365,6 +5387,36 @@ qup_spi23_data_clk: qup-spi23-data-clk-state { bias-disable; }; + qup_uart2_default: qup-uart2-default-state { + cts-pins { + pins = "gpio8"; + function = "qup0_se2"; + drive-strength = <2>; + bias-disable; + }; + + rts-pins { + pins = "gpio9"; + function = "qup0_se2"; + drive-strength = <2>; + bias-disable; + }; + + tx-pins { + pins = "gpio10"; + function = "qup0_se2"; + drive-strength = <2>; + bias-disable; + }; + + rx-pins { + pins = "gpio11"; + function = "qup0_se2"; + drive-strength = <2>; + bias-disable; + }; + }; + qup_uart21_default: qup-uart21-default-state { /* TX, RX */ pins = "gpio86", "gpio87"; -- 2.46.0