Add support for TypeC0 found on Forlinx OK3588-C. Powering the board
using this port is not supported, so set power-role to source.
Signed-off-by: Dmitry Yashin <dmt.yashin@xxxxxxxxx>
---
.../boot/dts/rockchip/rk3588-ok3588-c.dts | 110 ++++++++++++++++++
1 file changed, 110 insertions(+)
diff --git a/arch/arm64/boot/dts/rockchip/rk3588-ok3588-c.dts b/arch/arm64/boot/dts/rockchip/rk3588-ok3588-c.dts
index c2a08bdf09e8..1b6bfa2b1a69 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588-ok3588-c.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3588-ok3588-c.dts
@@ -1,6 +1,7 @@
// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
/dts-v1/;
+#include <dt-bindings/usb/pd.h>
#include "rk3588-fet3588-c.dtsi"
/ {
@@ -100,6 +101,18 @@ masterdai: simple-audio-card,codec {
};
};
+ vbus5v0_typec0: vbus5v0-typec0-regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "vbus5v0_typec0";
+ enable-active-high;
+ gpio = <&gpio0 RK_PD0 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&typec5v_0_pwren>;
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ vin-supply = <&vcc5v0_sys>;
+ };
+
vcc12v_dcin: vcc12v-dcin-regulator {
compatible = "regulator-fixed";
regulator-name = "vcc12v_dcin";
@@ -206,6 +219,51 @@ &gpu {
&i2c2 {
status = "okay";
+ usbc0: usb-typec@22 {
+ compatible = "fcs,fusb302";
+ reg = <0x22>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <RK_PB0 IRQ_TYPE_LEVEL_LOW>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&usbc0_int>;
+ vbus-supply = <&vbus5v0_typec0>;
+
+ usb_con0: connector {
+ compatible = "usb-c-connector";
+ label = "USB-C";
+ data-role = "dual";
+ power-role = "source";
+ source-pdos =
+ <PDO_FIXED(5000, 2000, PDO_FIXED_USB_COMM)>;
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ reg = <0>;
+ usbc0_hs: endpoint {
+ remote-endpoint = <&usb_host0_xhci_drd_sw>;
+ };
+ };
+
+ port@1 {
+ reg = <1>;
+ usbc0_ss: endpoint {
+ remote-endpoint = <&usbdp_phy0_typec_ss>;
+ };
+ };
+
+ port@2 {
+ reg = <2>;
+ usbc0_sbu: endpoint {
+ remote-endpoint = <&usbdp_phy0_typec_sbu>;
+ };
+ };
+ };
+ };
+ };
+
tca6424a: gpio@23 {
compatible = "ti,tca6424";
reg = <0x23>;
@@ -349,6 +407,16 @@ tca6424a_int: tca6424a-int {
rockchip,pins = <1 RK_PA4 RK_FUNC_GPIO &pcfg_pull_up>;
};
};
+
+ usb-typec {
+ typec5v_0_pwren: typec5v-0-pwren {
+ rockchip,pins = <0 RK_PD0 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+
+ usbc0_int: usbc0-int {
+ rockchip,pins = <1 RK_PB0 RK_FUNC_GPIO &pcfg_pull_up>;
+ };
+ };
};
&pwm2 {
@@ -378,6 +446,14 @@ &tsadc {
status = "okay";
};
+&u2phy0 {
+ status = "okay";
+};
+
+&u2phy0_otg {
+ status = "okay";
+};
+
&u2phy2 {
status = "okay";
};
@@ -394,6 +470,29 @@ &u2phy3_host {
status = "okay";
};
+&usbdp_phy0 {
+ mode-switch;
+ orientation-switch;
+ sbu1-dc-gpios = <&gpio4 RK_PA0 GPIO_ACTIVE_HIGH>;
+ sbu2-dc-gpios = <&gpio4 RK_PB0 GPIO_ACTIVE_HIGH>;
+ status = "okay";
+
+ port {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ usbdp_phy0_typec_ss: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&usbc0_ss>;
+ };
+
+ usbdp_phy0_typec_sbu: endpoint@1 {
+ reg = <1>;
+ remote-endpoint = <&usbc0_sbu>;
+ };
+ };
+};
+
&usb_host0_ehci {
status = "okay";
};
@@ -402,6 +501,17 @@ &usb_host0_ohci {
status = "okay";
};
+&usb_host0_xhci {
+ usb-role-switch;
+ status = "okay";
+
+ port {
+ usb_host0_xhci_drd_sw: endpoint {
+ remote-endpoint = <&usbc0_hs>;
+ };
+ };
+};
+
&usb_host1_ehci {
status = "okay";
};
--
2.39.2
