This series implements support for the Synopsys DesignWare HDMI RX Controller, being compliant with standard HDMI 1.4b and HDMI 2.0. Features that are currently supported by the HDMI RX driver have been tested on rock5b board using a HDMI to micro-HDMI cable. It is recommended to use a good quality cable as there were multiple issues seen during testing the driver. Please note the below information :- * While testing the driver on rock5b we noticed that the binary BL31 from Rockchip contains some unknown code to get the HDMI-RX PHY access working without any errors. With TF-A BL31, the HDMI-RX PHY also works fine but there were no interrupts seen for rk_hdmirx-hdmi leading to some errors when loading the driver [0]. It doesn't affect the functionality of the driver though. * We have tested the working of OBS studio with HDMIRX driver and there were no issues seen. * We also tested and verified the support for interlaced video. [0] https://gitlab.collabora.com/hardware-enablement/rockchip-3588/trusted-firmware-a/-/issues/1 To test the HDMI RX Controller driver, following example commands can be used :- root@debian-rockchip-rock5b-rk3588:~# v4l2-ctl --verbose -d /dev/video0 \ --set-fmt-video=width=1920,height=1080,pixelformat='BGR3' --stream-mmap=4 \ --stream-skip=3 --stream-count=100 --stream-to=/home/hdmiin4k.raw --stream-poll root@debian-rockchip-rock5b-rk3588:~# ffmpeg -f rawvideo -vcodec rawvideo \ -s 1920x1080 -r 60 -pix_fmt bgr24 -i /home/hdmiin4k.raw output.mkv CEC compliance test results :- * https://gitlab.collabora.com/-/snippets/381 * https://gitlab.collabora.com/-/snippets/380 Following is the v4l2-compliance test result :- root@debian-rockchip-rock5b-rk3588:~# v4l2-compliance -d /dev/video0 v4l2-compliance 1.27.0-5220, 64 bits, 64-bit time_t v4l2-compliance SHA: 8387e3673837 2024-07-01 11:09:32 Compliance test for snps_hdmirx device /dev/video0: Driver Info: Driver name : snps_hdmirx Card type : snps_hdmirx Bus info : platform:fdee0000.hdmi-receiver Driver version : 6.10.0 Capabilities : 0x84201000 Video Capture Multiplanar Streaming Extended Pix Format Device Capabilities Device Caps : 0x04201000 Video Capture Multiplanar Streaming Extended Pix Format Required ioctls: test VIDIOC_QUERYCAP: OK test invalid ioctls: OK Allow for multiple opens: test second /dev/video0 open: OK test VIDIOC_QUERYCAP: OK test VIDIOC_G/S_PRIORITY: OK test for unlimited opens: OK Debug ioctls: test VIDIOC_DBG_G/S_REGISTER: OK (Not Supported) test VIDIOC_LOG_STATUS: OK Input ioctls: test VIDIOC_G/S_TUNER/ENUM_FREQ_BANDS: OK (Not Supported) test VIDIOC_G/S_FREQUENCY: OK (Not Supported) test VIDIOC_S_HW_FREQ_SEEK: OK (Not Supported) test VIDIOC_ENUMAUDIO: OK (Not Supported) test VIDIOC_G/S/ENUMINPUT: OK test VIDIOC_G/S_AUDIO: OK (Not Supported) Inputs: 1 Audio Inputs: 0 Tuners: 0 Output ioctls: test VIDIOC_G/S_MODULATOR: OK (Not Supported) test VIDIOC_G/S_FREQUENCY: OK (Not Supported) test VIDIOC_ENUMAUDOUT: OK (Not Supported) test VIDIOC_G/S/ENUMOUTPUT: OK (Not Supported) test VIDIOC_G/S_AUDOUT: OK (Not Supported) Outputs: 0 Audio Outputs: 0 Modulators: 0 Input/Output configuration ioctls: test VIDIOC_ENUM/G/S/QUERY_STD: OK (Not Supported) test VIDIOC_ENUM/G/S/QUERY_DV_TIMINGS: OK test VIDIOC_DV_TIMINGS_CAP: OK test VIDIOC_G/S_EDID: OK Control ioctls (Input 0): test VIDIOC_QUERY_EXT_CTRL/QUERYMENU: OK test VIDIOC_QUERYCTRL: OK test VIDIOC_G/S_CTRL: OK test VIDIOC_G/S/TRY_EXT_CTRLS: OK test VIDIOC_(UN)SUBSCRIBE_EVENT/DQEVENT: OK test VIDIOC_G/S_JPEGCOMP: OK (Not Supported) Standard Controls: 3 Private Controls: 0 Format ioctls (Input 0): test VIDIOC_ENUM_FMT/FRAMESIZES/FRAMEINTERVALS: OK test VIDIOC_G/S_PARM: OK test VIDIOC_G_FBUF: OK (Not Supported) test VIDIOC_G_FMT: OK test VIDIOC_TRY_FMT: OK test VIDIOC_S_FMT: OK test VIDIOC_G_SLICED_VBI_CAP: OK (Not Supported) test Cropping: OK (Not Supported) test Composing: OK (Not Supported) test Scaling: OK (Not Supported) Codec ioctls (Input 0): test VIDIOC_(TRY_)ENCODER_CMD: OK (Not Supported) test VIDIOC_G_ENC_INDEX: OK (Not Supported) test VIDIOC_(TRY_)DECODER_CMD: OK (Not Supported) Buffer ioctls (Input 0): test VIDIOC_REQBUFS/CREATE_BUFS/QUERYBUF: OK test CREATE_BUFS maximum buffers: OK test VIDIOC_REMOVE_BUFS: OK test VIDIOC_EXPBUF: OK test Requests: OK (Not Supported) Total for snps_hdmirx device /dev/video0: 47, Succeeded: 47, Failed: 0, Warnings: 0 Changes in v4 :- - Remove DTS changes included in the device tree patch - Remove the hdmi rx pin info as it's already present in the rk3588-base-pinctrl.dtsi - Create a separate config option for selecting the EDID and enable it by default - Improve the comment related to DV timings and move it to the side of hdmirx_get_detected_timings - Add 100ms delay before pulling the HPD high - Do not return the detected timings from VIDIOC_G_DV_TIMINGS - Drop the bus info from hdmirx_querycap - If *num_planes != 0 then return 0 in hdmirx_queue_setup - Set queue->min_queued_buffers to 1 - Drop q->allow_cache_hints = 0; as it's always 0 by default - Add a comment for q->dma_attrs = DMA_ATTR_FORCE_CONTIGUOUS; - Drop .read = vb2_fop_read as it's not supported by driver - Remove redundant edid_init_data_600M - Make HPD low when driver is loaded - Add support for reading AVI Infoframe - Remove msg_len checks from hdmirx_cec_transmit - Add info about the CEC compliance test in the cover letter - Add arbitration lost status - Validate the physical address inside the EDID Changes in v3 :- - Use v4l2-common helpers in the HDMIRX driver - Rename cma node and phandle names - Elaborate the comment to explain 160MiB calculation - Move &hdmi_receiver_cma to the rock5b dts file - Add information about interlaced video testing in the cover-letter Changes in v2 :- - Fix checkpatch --strict warnings - Move the dt-binding include file changes in a separate patch - Add a description for the hardware in the dt-bindings file - Rename resets, vo1 grf and HPD properties - Add a proper description for grf and vo1-grf phandles in the bindings - Rename the HDMI RX node name to hdmi-receiver - Include gpio header file in binding example to fix the dt_binding_check failure - Move hdmirx_cma node to the rk3588.dtsi file - Add an entry to MAINTAINERS file for the HDMIRX driver Shreeya Patel (4): MAINTAINERS: Add entry for Synopsys DesignWare HDMI RX Driver dt-bindings: media: Document bindings for HDMI RX Controller arm64: dts: rockchip: Add device tree support for HDMI RX Controller media: platform: synopsys: Add support for hdmi input driver .../bindings/media/snps,dw-hdmi-rx.yaml | 132 + MAINTAINERS | 8 + .../dts/rockchip/rk3588-base-pinctrl.dtsi | 14 + .../arm64/boot/dts/rockchip/rk3588-extra.dtsi | 56 + drivers/media/platform/Kconfig | 1 + drivers/media/platform/Makefile | 1 + drivers/media/platform/synopsys/Kconfig | 3 + drivers/media/platform/synopsys/Makefile | 2 + .../media/platform/synopsys/hdmirx/Kconfig | 27 + .../media/platform/synopsys/hdmirx/Makefile | 4 + .../platform/synopsys/hdmirx/snps_hdmirx.c | 2763 +++++++++++++++++ .../platform/synopsys/hdmirx/snps_hdmirx.h | 394 +++ .../synopsys/hdmirx/snps_hdmirx_cec.c | 285 ++ .../synopsys/hdmirx/snps_hdmirx_cec.h | 44 + 14 files changed, 3734 insertions(+) create mode 100644 Documentation/devicetree/bindings/media/snps,dw-hdmi-rx.yaml create mode 100644 drivers/media/platform/synopsys/Kconfig create mode 100644 drivers/media/platform/synopsys/Makefile create mode 100644 drivers/media/platform/synopsys/hdmirx/Kconfig create mode 100644 drivers/media/platform/synopsys/hdmirx/Makefile create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx.c create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx.h create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx_cec.c create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx_cec.h -- 2.39.2
