On Tue, Jun 25, 2024 at 04:49:29PM GMT, Sagar Cheluvegowda wrote:
> Add interconnect support to vote for bus bandwidth based
> on the current speed of the driver.This change adds support
> for two different paths - one from ethernet to DDR and the
> other from Apps to ethernet.
"APPS" is a qualcomm term, since you're trying to go the generic route
here maybe just say CPU to ethernet?
> Vote from each interconnect client is aggregated and the on-chip
> interconnect hardware is configured to the most appropriate
> bandwidth profile.
>
> Suggested-by: Andrew Halaney <ahalaney@xxxxxxxxxx>
> Signed-off-by: Sagar Cheluvegowda <quic_scheluve@xxxxxxxxxxx>
> ---
> drivers/net/ethernet/stmicro/stmmac/stmmac.h | 1 +
> drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++++++++
> drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c | 12 ++++++++++++
> include/linux/stmmac.h | 2 ++
> 4 files changed, 23 insertions(+)
>
> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac.h b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
> index b23b920eedb1..56a282d2b8cd 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac.h
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
> @@ -21,6 +21,7 @@
> #include <linux/ptp_clock_kernel.h>
> #include <linux/net_tstamp.h>
> #include <linux/reset.h>
> +#include <linux/interconnect.h>
> #include <net/page_pool/types.h>
> #include <net/xdp.h>
> #include <uapi/linux/bpf.h>
> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> index b3afc7cb7d72..ec7c61ee44d4 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
> @@ -985,6 +985,12 @@ static void stmmac_fpe_link_state_handle(struct stmmac_priv *priv, bool is_up)
> }
> }
>
> +static void stmmac_set_icc_bw(struct stmmac_priv *priv, unsigned int speed)
> +{
> + icc_set_bw(priv->plat->axi_icc_path, Mbps_to_icc(speed), Mbps_to_icc(speed));
> + icc_set_bw(priv->plat->ahb_icc_path, Mbps_to_icc(speed), Mbps_to_icc(speed));
> +}
> +
> static void stmmac_mac_link_down(struct phylink_config *config,
> unsigned int mode, phy_interface_t interface)
> {
> @@ -1080,6 +1086,8 @@ static void stmmac_mac_link_up(struct phylink_config *config,
> if (priv->plat->fix_mac_speed)
> priv->plat->fix_mac_speed(priv->plat->bsp_priv, speed, mode);
>
> + stmmac_set_icc_bw(priv, speed);
> +
> if (!duplex)
> ctrl &= ~priv->hw->link.duplex;
> else
> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
> index 54797edc9b38..e46c94b643a3 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
> @@ -642,6 +642,18 @@ stmmac_probe_config_dt(struct platform_device *pdev, u8 *mac)
> dev_dbg(&pdev->dev, "PTP rate %d\n", plat->clk_ptp_rate);
> }
>
> + plat->axi_icc_path = devm_of_icc_get(&pdev->dev, "axi");
> + if (IS_ERR(plat->axi_icc_path)) {
> + ret = (void *)plat->axi_icc_path;
> + goto error_hw_init;
> + }
> +
> + plat->ahb_icc_path = devm_of_icc_get(&pdev->dev, "ahb");
> + if (IS_ERR(plat->ahb_icc_path)) {
> + ret = (void *)plat->ahb_icc_path;
> + goto error_hw_init;
> + }
> +
> plat->stmmac_rst = devm_reset_control_get_optional(&pdev->dev,
> STMMAC_RESOURCE_NAME);
> if (IS_ERR(plat->stmmac_rst)) {
> diff --git a/include/linux/stmmac.h b/include/linux/stmmac.h
> index f92c195c76ed..385f352a0c23 100644
> --- a/include/linux/stmmac.h
> +++ b/include/linux/stmmac.h
> @@ -283,6 +283,8 @@ struct plat_stmmacenet_data {
> struct reset_control *stmmac_rst;
> struct reset_control *stmmac_ahb_rst;
> struct stmmac_axi *axi;
> + struct icc_path *axi_icc_path;
> + struct icc_path *ahb_icc_path;
> int has_gmac4;
> int rss_en;
> int mac_port_sel_speed;
>
> --
> 2.34.1
>
