On 24.06.2024 3:30 AM, Caleb Connolly wrote: > Initial support for USB, UFS, touchscreen, panel, wifi, and bluetooth. > > Co-developed-by: Frieder Hannenheim <frieder.hannenheim@xxxxxxxxx> > Signed-off-by: Frieder Hannenheim <frieder.hannenheim@xxxxxxxxx> > Signed-off-by: Caleb Connolly <caleb@xxxxxxxxxxxxxxxx> > --- [...] > +&adsp { > + status = "okay"; > + firmware-name = "qcom/sm8250/OnePlus/adsp.mbn"; > +}; Status last pls [...] > +&gmu { > + status = "okay"; > +}; already enabled (or should be) [...] > +/* LS-I2C1 */ > +&i2c15 { > + status = "okay"; > + > + // fcs,fsa4480 @ 42 Just describe it ;) [...] > + /* FIXME: There is a bug somewhere in the display stack and it isn't /* * FIXME: > + * possible to get the panel to a working state after toggling reset. > + * At best it just shows one or more vertical red lines. So for now > + * let's skip the reset GPIO. > + */ > + // reset-gpios = <&tlmm 75 GPIO_ACTIVE_LOW>; /* */ [...] > +&ufs_mem_hc { > + status = "okay"; > + > + vcc-supply = <&vreg_l17a_3p0>; > + vcc-max-microamp = <800000>; > + vccq-supply = <&vreg_l6a_1p2>; > + vccq-max-microamp = <800000>; > + vccq2-supply = <&vreg_s4a_1p8>; > + vccq2-max-microamp = <800000>; allow set mode + allowed modes Konrad