Am Mittwoch, 12. Juni 2024, 22:48:11 CEST schrieb Sebastian Kropatsch: > Fix the alphabetical ordering in some nodes and rename some regulators > and pins to match the schematics [1][2] as well as to adhere to > preferred naming schemes. General rule of thumb, when you need an "and" in your subject or a list like the above - you definitly want to split the change into multiple commits. > In addition to that: > * vcc_3v3_sd_s0: Fix voltage to be 3.3V > * vcc3v3_pcie: > - Move to NanoPi R6C, this power switch is not available on R6S > - Fix vin-supply (is vcc_5v0 per schematics) > - Add gpios/pincrtl to enable power this defnitly needs its own patch > * vcc5v0_usb: Remove this regulator since according to the schematics, this too > * vcc5v0_host_20 and vcc5v0_usb_otg0 are directly powered by vcc_5v0 this could be grouped together with the 3.3v change > * gmac1: Add rx_delay of 0 (no delay since phy-mode = "rgmii-rxid") with rxid mode, why is the rx_delay needed at all? Shouldn't this just work without the property? > * rgmii_phy1: Add phy-supply as seen in schematics separate patch > * pcie2*: > - Add pinctrl reset pins > - Update vpcie3v3-supply to match the schematics separate patch > * sdhci: Add vmmc-supply and vqmmc-supply separate patch Heiko
