On 6/19/2024 3:06 AM, Konrad Dybcio wrote:
On 6/18/24 09:22, Tengfei Fan wrote:
AIM300 Series is a highly optimized family of modules designed to
support AIoT applications. It integrates QCS8550 SoC, UFS and PMIC
chip etc.
Here is a diagram of AIM300 SoM:
+----------------------------------------+
|AIM300 SoM |
| |
| +-----+ |
| |--->| UFS | |
| | +-----+ |
| | |
| | |
3.7v | +-----------------+ | +---------+ |
---------->| PMIC |----->| QCS8550 | |
| +-----------------+ +---------+ |
| | |
| | |
| | +-----+ |
| |--->| ... | |
| +-----+ |
| |
+----------------------------------------+
Co-developed-by: Fenglin Wu <quic_fenglinw@xxxxxxxxxxx>
Signed-off-by: Fenglin Wu <quic_fenglinw@xxxxxxxxxxx>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
Signed-off-by: Tengfei Fan <quic_tengfan@xxxxxxxxxxx>
---
[...]
+&ufs_mem_hc {
+ reset-gpios = <&tlmm 210 GPIO_ACTIVE_LOW>;
+ vcc-supply = <&vreg_l17b_2p5>;
+ vcc-max-microamp = <1300000>;
+ vccq-supply = <&vreg_l1g_1p2>;
+ vccq-max-microamp = <1200000>;
+ vdd-hba-supply = <&vreg_l3g_1p2>;
These regulators should generally have:
regulator-allow-set-load;
regulator-allowed-modes = <RPMH_REGULATOR_MODE_LPM
RPMH_REGULATOR_MODE_HPM>;
although the current setup you have never lets them exit HPM
Konrad
I understand your point is that these settings need to be added to
allthe child regulator nodes of regulators-0, regulators-1,
regulators-2, regulators-3, regulators-4 and regulators-5. Is that correct?
--
Thx and BRs,
Tengfei Fan
