W dniu 14.06.2024 o 12:29, Hui Wang pisze:
> In some designs, the chip reset pin is connected to a GPIO, and this
> GPIO needs to be set correctly before probing the driver, so add a
> reset-gpios in the device tree.
>
> Acked-by: Conor Dooley <conor.dooley@xxxxxxxxxxxxx>
> Signed-off-by: Hui Wang <hui.wang@xxxxxxxxxxxxx>
> ---
> No change in the v5
>
> Documentation/devicetree/bindings/serial/nxp,sc16is7xx.yaml | 5 +++++
> 1 file changed, 5 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.yaml b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.yaml
> index 5dec15b7e7c3..88871480018e 100644
> --- a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.yaml
> +++ b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.yaml
> @@ -28,6 +28,9 @@ properties:
> clocks:
> maxItems: 1
>
> + reset-gpios:
> + maxItems: 1
> +
> clock-frequency:
> description:
> When there is no clock provider visible to the platform, this
> @@ -91,6 +94,7 @@ unevaluatedProperties: false
> examples:
> - |
> #include <dt-bindings/interrupt-controller/irq.h>
> + #include <dt-bindings/gpio/gpio.h>
> i2c {
> #address-cells = <1>;
> #size-cells = <0>;
> @@ -120,6 +124,7 @@ examples:
> compatible = "nxp,sc16is752";
> reg = <0x54>;
> clocks = <&clk20m>;
> + reset-gpios = <&gpio5 13 GPIO_ACTIVE_LOW>;
> interrupt-parent = <&gpio3>;
> interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
> nxp,modem-control-line-ports = <0 1>; /* Ports 0 and 1 as modem control lines */
> --
> 2.34.1
Reviewed-by: Lech Perczak <lech.perczak@xxxxxxxxxxxxxxx>
--
Pozdrawiam/With kind regards,
Lech Perczak
Sr. Software Engineer
Camlin Technologies Poland Limited Sp. z o.o.
Strzegomska 54,
53-611 Wroclaw
Tel: (+48) 71 75 000 16
Email: lech.perczak@xxxxxxxxxxxxxxx
Website: http://www.camlingroup.com
