Andreas Schwab wrote: > On Mai 10 2024, Emil Renner Berthing wrote: > > > You don't include any information useful for debugging this, but if it get's > > far enough to load the firmware could you at least make sure you run the > > version below, so that's at least the same. > > > > https://github.com/esmil/linux/blob/visionfive/firmware/brcm/BCM43430A1.hcd > > That didn't change anything (and there are no messages related to > firmware loading from hci_uart). > > [ +0.879623] Bluetooth: Core ver 2.22 > [ +0.004843] NET: Registered PF_BLUETOOTH protocol family > [ +0.008787] Bluetooth: HCI device and connection manager initialized > [ +0.021944] Bluetooth: HCI socket layer initialized > [ +0.008488] Bluetooth: L2CAP socket layer initialized > [ +0.006333] Bluetooth: SCO socket layer initialized > [ +0.097478] Bluetooth: HCI UART driver ver 2.3 > [ +0.007943] Bluetooth: HCI UART protocol H4 registered > [ +0.006066] Bluetooth: HCI UART protocol BCSP registered > [ +0.006962] Bluetooth: HCI UART protocol LL registered > [ +0.000015] Bluetooth: HCI UART protocol ATH3K registered > [ +0.000084] Bluetooth: HCI UART protocol Three-wire (H5) registered > [ +0.000247] Bluetooth: HCI UART protocol Intel registered > [ +0.000455] Bluetooth: HCI UART protocol Broadcom registered > [ +0.000084] Bluetooth: HCI UART protocol QCA registered > [ +0.000008] Bluetooth: HCI UART protocol AG6XX registered > [ +0.000057] Bluetooth: HCI UART protocol Marvell registered > [ +0.051854] hci_uart_bcm serial0-0: supply vbat not found, using dummy regulator > [ +0.000387] hci_uart_bcm serial0-0: supply vddio not found, using dummy regulator > [ +0.094658] hci_uart_bcm serial0-0: No reset resource, using default baud rate > [ +0.990297] Bluetooth: hci0: command 0x1001 tx timeout > [ +0.022893] Bluetooth: hci0: BCM: Reading local version info failed (-110) > [ +3.306159] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 > [ +0.013336] Bluetooth: BNEP filters: protocol multicast > [ +0.124262] Bluetooth: BNEP socket layer initialized Oddly it doesn't work on my Starlight board either. I was thinking the firmware might set up pinconf differently, but comparing /sys/kernel/debug/pinctrl/11910000.pinctrl-pinctrl-starfive/pinconf-pins on the two boards shows no differences. I've also not been able to spot any differences in how the AP6236 module is connected in the schematics for the two boards, so not really sure how to proceed. If you're also testing on the Starlight board then I can update the patch to just enable Bluetooth on that I guess. /Emil
