On Tue, 28 May 2024 07:23:03 +0000 Arthur Becker <arthur.becker@xxxxxxxxxx> wrote: > Thanks for the Review! > Right, I wasn't sure if and how to add the veml6040 to the veml6075 dt-binding file. > I'll modify that the next time I make adjustments to the driver. It's absolutely fine to have shared bindings even if the drivers (because of different register interface etc) are completely separate. It's a good way to keep bindings aligned between similar devices. Jonathan > > Kind regards, > Arthur > > ________________________________________ > From: Krzysztof Kozlowski <krzk@xxxxxxxxxx> > Sent: 27 May 2024 18:31 > To: Arthur Becker; Jonathan Cameron; Lars-Peter Clausen; Rob Herring; Krzysztof Kozlowski; Conor Dooley > Cc: linux-kernel@xxxxxxxxxxxxxxx; linux-iio@xxxxxxxxxxxxxxx; devicetree@xxxxxxxxxxxxxxx > Subject: [EXTERNAL]Re: [PATCH v3 2/2] dt-bindings: iio: light: add VEML6040 RGBW-LS bindings > > On 27/05/2024 17:12, Arthur Becker via B4 Relay wrote: > > From: Arthur Becker <arthur.becker@xxxxxxxxxx> > > > > Device tree bindings for the vishay VEML6040 RGBW light sensor iio > > driver > > > > Signed-off-by: Arthur Becker <arthur.becker@xxxxxxxxxx> > > --- > > V1 -> V3: Addressed review comments (v1 of the dt-bindings was sent > > along with v2 of the driver but not in a set) > > It's basically the same as veml6075, so should be put there... > > Eh, > > Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> > > Best regards, > Krzysztof > >