On Wed, 8 May 2024 at 10:38, Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> wrote: > > On 07/05/2024 21:20, Abhinav Kumar wrote: > > > > > > On 5/7/2024 9:35 AM, Krzysztof Kozlowski wrote: > >> On 07/05/2024 18:30, Venkata Prahlad Valluru wrote: > >>> Rb3Gen2 has a lt9611uxc DSI-to-HDMI bridge on i2c0, with > >>> reset gpio from pm7250b gpio2 and irq gpio from tlmm gpio24. > >>> Bridge supplies are Vdd connected to input supply directly > >>> and vcc to L11c. Enable HDMI output, bridge and corresponding > >>> DSI output. > >>> > >>> Signed-off-by: Venkata Prahlad Valluru <quic_vvalluru@xxxxxxxxxxx> > >>> --- > >>> v3: - Updated commit text > >>> - Arranged nodes in alphabetical order > >>> - Fixed signoff > >>> - Fixed drive strength for lt9611_irq_pin > >>> - Removed 'label' from hdmi-connector, which is optional > >> > >> Please respond to each Bjorn comment and explain how did you implement it... > >> > > > > Yes, agreed. Even though it seems like you mostly just agreed to mine > > and Bjorn's suggestions and decided to implement all those in v3 , it > > would have been better to explicitly ack them or tell why you agreed or > > what went wrong that you had not done it in v2 itself to close the loop. > > The problem is that one or more were ignored... By responding to each of > them, I hope they will be finally read and understood instead of > repeating the same mistake three times. I found a mistake that was repeated two times. This leaves me wondering which mistake was repeated three times. -- With best wishes Dmitry
