On 07/05/2024 21:20, Abhinav Kumar wrote: > > > On 5/7/2024 9:35 AM, Krzysztof Kozlowski wrote: >> On 07/05/2024 18:30, Venkata Prahlad Valluru wrote: >>> Rb3Gen2 has a lt9611uxc DSI-to-HDMI bridge on i2c0, with >>> reset gpio from pm7250b gpio2 and irq gpio from tlmm gpio24. >>> Bridge supplies are Vdd connected to input supply directly >>> and vcc to L11c. Enable HDMI output, bridge and corresponding >>> DSI output. >>> >>> Signed-off-by: Venkata Prahlad Valluru <quic_vvalluru@xxxxxxxxxxx> >>> --- >>> v3: - Updated commit text >>> - Arranged nodes in alphabetical order >>> - Fixed signoff >>> - Fixed drive strength for lt9611_irq_pin >>> - Removed 'label' from hdmi-connector, which is optional >> >> Please respond to each Bjorn comment and explain how did you implement it... >> > > Yes, agreed. Even though it seems like you mostly just agreed to mine > and Bjorn's suggestions and decided to implement all those in v3 , it > would have been better to explicitly ack them or tell why you agreed or > what went wrong that you had not done it in v2 itself to close the loop. The problem is that one or more were ignored... By responding to each of them, I hope they will be finally read and understood instead of repeating the same mistake three times. Best regards, Krzysztof
