Re: [PATCH v3 3/3] arm64: dts: qcom: Add initial support for rb5gen2 board

[Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>]

On 3/13/24 08:12, Wasim Nazir wrote:
> RB5gen2 is based on QCS8550-Rb5gen2 SOM for IOT solutions.
> This initial version describes VPH_PWR, UART & USB3.1(HS).
>
> On-board PMICs:
> - PMR735D
> - PM8010
>
> Signed-off-by: Wasim Nazir <quic_wasimn@xxxxxxxxxxx>

Where's the "---"? :thinking:

[...]

> +&apps_rsc {
> +	regulators-0 {

This does not scale. Use &label references instead

> +		vdd-bob1-supply = <&vph_pwr>;
> +		vdd-bob2-supply = <&vph_pwr>;
> +	};
> +
> +	regulators-2 {
> +		vdd-s4-supply = <&vph_pwr>;
> +		vdd-s5-supply = <&vph_pwr>;
> +	};
> +
> +	regulators-3 {
> +		vdd-s1-supply = <&vph_pwr>;
> +		vdd-s3-supply = <&vph_pwr>;
> +		vdd-s4-supply = <&vph_pwr>;
> +		vdd-s5-supply = <&vph_pwr>;
> +		vdd-s6-supply = <&vph_pwr>;
> +	};
> +
> +	regulators-4 {
> +		vdd-s1-supply = <&vph_pwr>;
> +		vdd-s3-supply = <&vph_pwr>;
> +		vdd-s4-supply = <&vph_pwr>;
> +		vdd-s5-supply = <&vph_pwr>;
> +		vdd-s7-supply = <&vph_pwr>;
> +	};
> +
> +	regulators-5 {
> +		vdd-s1-supply = <&vph_pwr>;
> +		vdd-s2-supply = <&vph_pwr>;
> +		vdd-s3-supply = <&vph_pwr>;
> +		vdd-s4-supply = <&vph_pwr>;
> +		vdd-s5-supply = <&vph_pwr>;
> +		vdd-s6-supply = <&vph_pwr>;
> +	};
> +};
> +
> +&pm8550b_eusb2_repeater {
> +	vdd18-supply = <&vreg_l15b_1p8>;
> +	vdd3-supply = <&vreg_l5b_3p1>;
> +};

Would that not be SoM-common too?

Konrad