On Mon, 08 Apr 2024 11:59:30 +0300, Arseniy Krasnov wrote: > Boot ROM code on Meson requires that some pages on NAND must be written > in special mode: "short" ECC mode where each block is 384 bytes and > scrambling mode is on. Such pages located with the specified interval > within specified offset. Both interval and offset are located in the > device tree and used by driver if 'nand-is-boot-medium' is set for > NAND chip. > > Signed-off-by: Arseniy Krasnov <avkrasnov@xxxxxxxxxxxxxxxxx> > --- > .../bindings/mtd/amlogic,meson-nand.yaml | 14 ++++++++++++++ > 1 file changed, 14 insertions(+) > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: ./Documentation/devicetree/bindings/mtd/amlogic,meson-nand.yaml:84:61: [warning] too few spaces after comma (commas) ./Documentation/devicetree/bindings/mtd/amlogic,meson-nand.yaml:85:61: [warning] too few spaces after comma (commas) dtschema/dtc warnings/errors: doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20240408085931.456337-2-avkrasnov@xxxxxxxxxxxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.
