Hello, This small series includes a few drive-by fixes for DT validation errors. The first patch has been posted previously in v1 ([1], and now addresses a small review comment. I think it's good to go. The next two patches address the same issue as "[PATCH 1/2] dt-bindings: arm: bcm: raspberrypi,bcm2835-firmware: Add missing properties" ([2]), but this time with a (hopefully) correct approach. Patch 2/3 starts by fixing the raspberrypi-bcm2835-firmware driver, removing the need for DT properties that are specified in bcm2835-rpi.dtsi but not documented in the corresponding bindings. Patch 3/3 can then drop those properties, getting rid of the warnings. [1] https://lore.kernel.org/linux-arm-kernel/20240326004902.17054-3-laurent.pinchart@xxxxxxxxxxxxxxxx/ [2] https://lore.kernel.org/linux-arm-kernel/20240326004902.17054-2-laurent.pinchart@xxxxxxxxxxxxxxxx/ Laurent Pinchart (3): dt-bindings: arm: bcm: raspberrypi,bcm2835-firmware: Add gpio child node firmware: raspberrypi: Use correct device for DMA mappings ARM: dts: bcm283x: Drop unneeded properties in the bcm2835-firmware node .../arm/bcm/raspberrypi,bcm2835-firmware.yaml | 30 +++++++++++++++++++ .../gpio/raspberrypi,firmware-gpio.txt | 30 ------------------- arch/arm/boot/dts/broadcom/bcm2835-rpi.dtsi | 4 --- drivers/firmware/raspberrypi.c | 7 +++-- 4 files changed, 34 insertions(+), 37 deletions(-) delete mode 100644 Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt -- Regards, Laurent Pinchart