This series aims to add support for Rockchip RK816 PMIC series. As per datasheet it's targeted for RK3126/RK3128 (RK816-1), RK1108 (RK816-2) and PX3-SE (RK816-3) but might be used for other SoCs as well. The mfd consists of an integrated RTC, a GPIO controller, two 32k clock outputs, a power key (output), 4 buck- and 5 ldo regulators, 3 regulator-switches, and charger with integrated fuel gauge. Charger and fuel gauge are not part of this series. Two of the switches (otg/boost) are part of the binding, but not of the driver. They must only ever by enabled if no battery charging is happening, but it will be enabled automatically if a battery is attached. Thus they need some incorporation of a yet to be added charger driver. Integration in the existing rk8xx-infrastructure was pretty straightforward and only needed very little tweaking. In order to not further bloat the driver(s) too much with additional definitions I tried to re-use existing ones wherever possible. The patches are loosely based on the vendor's implementation, verified against the datasheet and tested/measured on RK3126 board. As they are touching several subsystems I'm sending them (very) early for the 6.10-cycle. Alex Bee (5): dt-bindings: mfd: Add rk816 binding mfd: rk8xx: Add RK816 support pinctrl: rk805: Add rk816 pinctrl support regulator: rk808: Support apply_bit for rk808_set_suspend_voltage_range regulator: rk808: Add RK816 support .../bindings/mfd/rockchip,rk816.yaml | 259 ++++++++++++++++++ drivers/mfd/Kconfig | 4 +- drivers/mfd/rk8xx-core.c | 103 +++++++ drivers/mfd/rk8xx-i2c.c | 45 ++- drivers/pinctrl/pinctrl-rk805.c | 68 +++++ drivers/regulator/rk808-regulator.c | 218 ++++++++++++++- include/linux/mfd/rk808.h | 141 ++++++++++ 7 files changed, 831 insertions(+), 7 deletions(-) create mode 100644 Documentation/devicetree/bindings/mfd/rockchip,rk816.yaml -- 2.43.2