Add device tree binding for SAM9X7 pin controller. Signed-off-by: Varshini Rajendran <varshini.rajendran@xxxxxxxxxxxxx> Acked-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> --- Changes in v4: - Updated Acked-by tag --- .../devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt | 2 ++ 1 file changed, 2 insertions(+) diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt index e8abbdad7b5d..0aa1a53012d6 100644 --- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt +++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt @@ -20,6 +20,7 @@ such as pull-up, multi drive, etc. Required properties for iomux controller: - compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl" or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pinctrl" + or "microchip,sam9x7-pinctrl", "microchip,sam9x60-pinctrl" - atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be configured in this periph mode. All the periph and bank need to be describe. @@ -120,6 +121,7 @@ Some requirements for using atmel,at91rm9200-pinctrl binding: For each bank the required properties are: - compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or "microchip,sam9x60-gpio" + or "microchip,sam9x7-gpio", "microchip,sam9x60-gpio", "atmel,at91rm9200-gpio" - reg: physical base address and length of the controller's registers - interrupts: interrupt outputs from the controller - interrupt-controller: marks the device node as an interrupt controller -- 2.25.1