Only Tx and Rx Signal lines for wkup_uart0 are brought out on the J784S4 EVM from SoC, but CTS and RTS signal lines are not brought on the EVM. Thus, remove pinmux for CTS and RTS signal lines for wkup_uart0 in J784S4. Fixes: 6fa5d37a2f34 ("arm64: dts: ti: k3-j784s4-evm: Add mcu and wakeup uarts") Signed-off-by: Bhavya Kapoor <b-kapoor@xxxxxx> --- arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 2 -- 1 file changed, 2 deletions(-) diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts index 57e7cb8ea2b8..9f16642ccd5f 100644 --- a/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts +++ b/arch/arm64/boot/dts/ti/k3-j784s4-evm.dts @@ -336,8 +336,6 @@ &wkup_pmx2 { wkup_uart0_pins_default: wkup-uart0-default-pins { bootph-all; pinctrl-single,pins = < - J721S2_WKUP_IOPAD(0x070, PIN_INPUT, 0) /* (L37) WKUP_GPIO0_6.WKUP_UART0_CTSn */ - J721S2_WKUP_IOPAD(0x074, PIN_INPUT, 0) /* (L36) WKUP_GPIO0_7.WKUP_UART0_RTSn */ J721S2_WKUP_IOPAD(0x048, PIN_INPUT, 0) /* (K35) WKUP_UART0_RXD */ J721S2_WKUP_IOPAD(0x04c, PIN_INPUT, 0) /* (K34) WKUP_UART0_TXD */ >; -- 2.34.1