WKUP_PADCONFIG registers for wakeup and mcu uart lies under wkup_pmx2 for J7200. Thus, modify pinmux for both of them. Only Tx and Rx Signal lines for wakeup uart are brought out on J721S2 Common Proc Board and J784S4 EVM, but CTS and RTS signal lines are not brought out. Thus, remove pinmux for CTS and RTS signal lines for wake up uart in J721S2 and J784S4. Rebased to 20240208 Bhavya Kapoor (3): arm64: dts: ti: k3-j7200-common-proc-board: Modify Pinmux for wakeup and mcu uart arm64: dts: ti: k3-j721s2-common-proc-board: Remove Pinmux for CTS and RTS in Wakeup Uart arm64: dts: ti: k3-j784s4-evm: Remove Pinmux for CTS and RTS in Wakeup Uart .../boot/dts/ti/k3-j7200-common-proc-board.dts | 18 +++++++++--------- .../dts/ti/k3-j721s2-common-proc-board.dts | 2 -- arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 2 -- 3 files changed, 9 insertions(+), 13 deletions(-) -- 2.34.1