Il 6 febbraio 2024 19:29:13 CET, Andrew Davis <afd@xxxxxx> ha scritto:
>On 1/26/24 10:51 AM, Francesco Dolcini wrote:
>> From: Francesco Dolcini <francesco.dolcini@xxxxxxxxxxx>
>>
>> Add TPM device to Mallow device tree file, the device is connected to
>> the SoC with SPI1/CS1, the same SPI interface is also available on an
>> extension header together with an additional CS0 signal.
>>
>> Signed-off-by: Francesco Dolcini <francesco.dolcini@xxxxxxxxxxx>
>> ---
>> arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi | 10 ++++++++++
>> 1 file changed, 10 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi b/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi
>> index 17b93534f658..77b1beb638ad 100644
>> --- a/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi
>> +++ b/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi
>> @@ -127,6 +127,16 @@ &main_spi1 {
>> <&pinctrl_qspi1_cs2_gpio>;
>> cs-gpios = <0>, <&main_gpio0 12 GPIO_ACTIVE_LOW>;
>> status = "okay";
>> +
>> + tpm@1 {
>> + compatible = "infineon,slb9670", "tcg,tpm_tis-spi";
>> + reg = <1>;
>> + pinctrl-names = "default";
>> + pinctrl-0 = <&pinctrl_qspi1_dqs_gpio>;
>> + interrupt-parent = <&main_gpio1>;
>> + interrupts = <18 IRQ_TYPE_EDGE_FALLING>;
>
>Just a heads-up, the SLB9670 datasheet says this device uses
>an active low interrupt (IRQ_TYPE_LEVEL_LOW). Using TYPE_EDGE
>here can cause missed interrupts if the line stays low for
>multiple interrupts.
The driver interrupt handler would need to take care of it, if needed.
The SOC does not support level interrupt, so there is no other solution, am I wrong?
Francesco
