The Synopsys i2c driver allows a user to override the parameters controlling the waveform using ACPI; this is useful for fine tuning when needed to make spec compliance. Extend this support to the device tree to allow non-ACPI platforms the same capabilities. Signed-off-by: Aahil Awatramani <aahila@xxxxxxxxxx> --- Documentation/devicetree/bindings/i2c/i2c.txt | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+) diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt b/Documentation/devicetree/bindings/i2c/i2c.txt index fc3dd7ec0445..3c33c36571f9 100644 --- a/Documentation/devicetree/bindings/i2c/i2c.txt +++ b/Documentation/devicetree/bindings/i2c/i2c.txt @@ -45,6 +45,24 @@ wants to support one of the below features, it should adapt these bindings. Number of nanoseconds the SCL signal takes to rise; t(r) in the I2C specification. +- i2c-scl-ss-hcnt + HCNT value for standard speed mode in I2C Controller. + +- i2c-scl-ss-lcnt + LCNT value for standard speed mode in I2C Controller. + +- i2c-scl-fs-hcnt + HCNT value for fast speed mode in I2C Controller. + +- i2c-scl-fs-lcnt + LCNT value for fast speed mode in I2C Controller. + +- i2c-scl-hs-hcnt + HCNT value for high speed mode in I2C Controller. + +- i2c-scl-hs-lcnt + LCNT value for high speed mode in I2C Controller. + - i2c-sda-falling-time-ns Number of nanoseconds the SDA signal takes to fall; t(f) in the I2C specification. -- 2.43.0.429.g432eaa2c6b-goog