Ajay Kumar wrote:
>
> Define videoports and use endpoints to describe the connection between
> the encoder, bridge and the panel, instead of using phandles.
>
> Signed-off-by: Ajay Kumar <ajaykumar.rs@xxxxxxxxxxx>
> Acked-by: Inki Dae <inki.dae@xxxxxxxxxxx>
> Tested-by: Rahul Sharma <rahul.sharma@xxxxxxxxxxx>
> Tested-by: Javier Martinez Canillas <javier.martinez@xxxxxxxxxxxxxxx>
> Tested-by: Gustavo Padovan <gustavo.padovan@xxxxxxxxxxxxxxx>
> Tested-by: Sjoerd Simons <sjoerd.simons@xxxxxxxxxxxxxxx>
> ---
> arch/arm/boot/dts/exynos5250-snow.dts | 30 ++++++++++++++++++++++++++++--
> 1 file changed, 28 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm/boot/dts/exynos5250-snow.dts b/arch/arm/boot/dts/exynos5250-snow.dts
> index b9aeec4..1bd5d3a 100644
> --- a/arch/arm/boot/dts/exynos5250-snow.dts
> +++ b/arch/arm/boot/dts/exynos5250-snow.dts
> @@ -183,7 +183,20 @@
> powerdown-gpios = <&gpy2 5 GPIO_ACTIVE_HIGH>;
> reset-gpios = <&gpx1 5 GPIO_ACTIVE_HIGH>;
> edid-emulation = <5>;
> - panel = <&panel>;
> +
> + ports {
> + port@0 {
> + bridge_out: endpoint {
> + remote-endpoint = <&panel_in>;
> + };
> + };
> +
> + port@1 {
> + bridge_in: endpoint {
> + remote-endpoint = <&dp_out>;
> + };
> + };
> + };
> };
> };
>
> @@ -228,6 +241,12 @@
> compatible = "auo,b116xw03";
> power-supply = <&fet6>;
> backlight = <&backlight>;
> +
> + port {
> + panel_in: endpoint {
> + remote-endpoint = <&bridge_out>;
> + };
> + };
> };
> };
>
> @@ -242,7 +261,14 @@
> samsung,link-rate = <0x0a>;
> samsung,lane-count = <2>;
> samsung,hpd-gpio = <&gpx0 7 GPIO_ACTIVE_HIGH>;
> - bridge = <&ptn3460>;
> +
> + ports {
> + port@0 {
> + dp_out: endpoint {
> + remote-endpoint = <&bridge_in>;
> + };
> + };
> + };
> };
>
> &ehci {
> --
> 1.7.9.5
I'm fine on the DT changes in this series, shall I take 13/14 and 14/14 in
Samsung tree?
- Kukjin
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
