Hi,
Am 29.12.23 um 17:48 schrieb Mathieu Othacehe:
Hey,
I also saw in the other Symphony DTS a LED for heartbeat. Is it usable, too?
Yes, I will add it to in v5.
According to the datasheet the SOM expose 7 UARTs, but only the debug
UART is enable. What is the reason for this?
So those 7 UARTs are:
UART1: console
UART2: used by the microphone
UART3: used by the resistive touch
UART4: used by the ethernet/resistive touch
UART5: on J18.4,6,8,10 (used by BT)
UART6: on J18.7 and J18.9 (available)
UART7: on J18.3 and J18.5 (used by the M33 firmware)
I will enable UART6, and add a mention about UART7, something like:
/* J18.7, J18.9 */
&lpuart6 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart6>;
status = "okay";
};
/* J18.3, J18.5 - used by M33 firmware */
&lpuart7 {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_uart7>;
status = "disabled";
};
in case this is used by the M33 firmware, this applies to all i.MX93 so
we don't need this. Just enable UART6 and keep UART7.
Btw the commit log mentions a Wifi (via SDIO?) and audio interface. This
is currently not supported by Linux?
I am not sure about that, and I would prefer to study that a bit later
on if that's OK :) I can remove it from the commit log as this is
misleading as not already supported / tested.
This sounds good. No need to have it all at first.
Thanks,
Mathieu
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
