Define enum inside the honeywell,transfer-function property block. Set the correct irq edge in the example block. Based on the datasheet, in table 13 on page 11: "End-of-conversion indicator: This pin is set high when a measurement and calculation have been completed and the data is ready to be clocked out" Add description on End-of-conversion interrupt. Signed-off-by: Petre Rodan <petre.rodan@xxxxxxxxxxxxxxx> Signed-off-by: Andreas Klinger <ak@xxxxxxxxxxxxx> --- .../bindings/iio/pressure/honeywell,mprls0025pa.yaml | 7 ++++++- 1 file changed, 6 insertions(+), 1 deletion(-) diff --git a/Documentation/devicetree/bindings/iio/pressure/honeywell,mprls0025pa.yaml b/Documentation/devicetree/bindings/iio/pressure/honeywell,mprls0025pa.yaml index d9e903fbfd99..84ced4e5a7da 100644 --- a/Documentation/devicetree/bindings/iio/pressure/honeywell,mprls0025pa.yaml +++ b/Documentation/devicetree/bindings/iio/pressure/honeywell,mprls0025pa.yaml @@ -42,6 +42,10 @@ properties: maxItems: 1 interrupts: + description: + Optional interrupt for indicating End-of-conversion. + If not present, the driver loops for a while until the received status + byte indicates correct measurement. maxItems: 1 reset-gpios: @@ -65,6 +69,7 @@ properties: 1 - A, 10% to 90% of 2^24 (1677722 .. 15099494) 2 - B, 2.5% to 22.5% of 2^24 (419430 .. 3774874) 3 - C, 20% to 80% of 2^24 (3355443 .. 13421773) + enum: [1, 2, 3] $ref: /schemas/types.yaml#/definitions/uint32 vdd-supply: @@ -93,7 +98,7 @@ examples: reg = <0x18>; reset-gpios = <&gpio3 19 GPIO_ACTIVE_HIGH>; interrupt-parent = <&gpio3>; - interrupts = <21 IRQ_TYPE_EDGE_FALLING>; + interrupts = <21 IRQ_TYPE_EDGE_RISING>; honeywell,pmin-pascal = <0>; honeywell,pmax-pascal = <172369>; honeywell,transfer-function = <1>; -- 2.41.0