Hi All, This series adds support for ICSSG ethernet on AM64x. This series is based on the latest next-20231211 linux-next. AM64x EVM has three ethernet ports. One is dedicated to CPSW and one is dedicated to ICSSG1. The remaining port is muxed between CPSW and ICSSG1 ICSSG1 ports. The ICSSG1 node is added in the k3-am642-evm.dts. By default the muxed port is used by CPSW so 2nd ICSSG1 port is disabled in the k3-am642-evm.dts. But overlay k3-am642-evm-icssg1-dualemac.dtso can be applied to use muxed port as ICSSG1. This is the v2 of the series [v1]. This addresses comments made on v1. Changes from v1 to v2: *) Fixed aliases section in k3-am642-evm.dts *) Fixed firmware-names in k3-am642-evm.dts *) Changed icssg1_phy1 to ethernet-phy@f from ethernet-phy@0 as suggested by Andrew L. *) Changed makefile to handle overlays using CONFIG_OF_ALL_DTBS as suggested by Nishant and Andrew Davis. *) Fixed aliases section in k3-am642-evm-icssg1-dualemac.dtso *) Fixed pinctrl in k3-am642-evm-icssg1-dualemac.dtso *) Updated commit message of patch 3/3 of the series to warn about adding label name to 'mdio-mux-1' node. [v1] https://lore.kernel.org/all/20231207081917.340167-1-danishanwar@xxxxxx/ Thanks and Regards, MD Danish Anwar MD Danish Anwar (2): arm64: dts: ti: k3-am642-evm: add ICSSG1 Ethernet support arm64: dts: ti: k3-am642-evm: add overlay for icssg1 2nd port Suman Anna (1): arm64: dts: ti: k3-am64-main: Add ICSSG IEP nodes arch/arm64/boot/dts/ti/Makefile | 7 +- arch/arm64/boot/dts/ti/k3-am64-main.dtsi | 24 ++++ .../dts/ti/k3-am642-evm-icssg1-dualemac.dtso | 75 +++++++++++++ arch/arm64/boot/dts/ti/k3-am642-evm.dts | 104 +++++++++++++++++- 4 files changed, 208 insertions(+), 2 deletions(-) create mode 100644 arch/arm64/boot/dts/ti/k3-am642-evm-icssg1-dualemac.dtso base-commit: bbd220ce4e29ed55ab079007cff0b550895258eb -- 2.34.1
