On 09/12/2023 16:41, Biju Das wrote: >> >> Why disabling? Drop all statuses from all your binding examples. >> >>>> Where are gpio-controller and cells? For this node and for parent? >>>> Why this example is incomplete? >>> >>> Currently I don't see any driver is using this compatible other than >> MFD. >> >> Open the MFD so you will see it... > > Actually, found the driver and tested GPIOs, > For input gpio, I can see the sd1_pwr_sel values are > toggled during card insert/removal. > For outout gpio, > System is entering into reset mode, if I set output-low in DT. So set > Init state as output-high to avoid reset. > > drivers/pinctrl/pinctrl-da9062.c Anyway there is a GPIO child node and driver which binds to it. What's its purpose in such case? Best regards, Krzysztof