From: Kevin Xie <kevin.xie@xxxxxxxxxxxxxxxx>
Add the PCIE_RESET_CONFIG_DEVICE_WAIT_MS macro to define the minimum
waiting time between exit from a conventional reset and sending the
first configuration request to the device.
As described in PCI base specification r6.0, section 6.6.1 <Conventional
Reset>, there are two different use cases of the value:
- "With a Downstream Port that does not support Link speeds greater
than 5.0 GT/s, software must wait a minimum of 100 ms following exit
from a Conventional Reset before sending a Configuration Request to
the device immediately below that Port."
- "With a Downstream Port that supports Link speeds greater than
5.0 GT/s, software must wait a minimum of 100 ms after Link training
completes before sending a Configuration Request to the device
immediately below that Port."
Signed-off-by: Kevin Xie <kevin.xie@xxxxxxxxxxxxxxxx>
Reviewed-by: Mason Huo <mason.huo@xxxxxxxxxxxxxxxx>
---
drivers/pci/pci.h | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/drivers/pci/pci.h b/drivers/pci/pci.h
index 5ecbcf041179..06f1f1eb878c 100644
--- a/drivers/pci/pci.h
+++ b/drivers/pci/pci.h
@@ -22,6 +22,22 @@
*/
#define PCIE_PME_TO_L2_TIMEOUT_US 10000
+/*
+ * As described in PCI base specification r6.0, section 6.6.1 <Conventional
+ * Reset>, there are two different use cases of the value:
+ *
+ * - "With a Downstream Port that does not support Link speeds greater
+ * than 5.0 GT/s, software must wait a minimum of 100 ms following exit
+ * from a Conventional Reset before sending a Configuration Request to
+ * the device immediately below that Port."
+ *
+ * - "With a Downstream Port that supports Link speeds greater than
+ * 5.0 GT/s, software must wait a minimum of 100 ms after Link training
+ * completes before sending a Configuration Request to the device
+ * immediately below that Port."
+ */
+#define PCIE_RESET_CONFIG_DEVICE_WAIT_MS 100
+
extern const unsigned char pcie_link_speed[];
extern bool pci_early_dump;
--
2.17.1
