From: Michael Walle <mwalle@xxxxxxxxxx> For a normal operation, the vdd supplies nor the stby GPIO is needed. There are boards, where these voltages are statically enabled during board power-up. The reset pin is required because once the PPI (PHY protocol interface) is started, it can only be stopped by asserting the reset pin. Signed-off-by: Michael Walle <mwalle@xxxxxxxxxx> Signed-off-by: Tony Lindgren <tony@xxxxxxxxxxx> --- .../devicetree/bindings/display/bridge/toshiba,tc358775.yaml | 3 --- 1 file changed, 3 deletions(-) diff --git a/Documentation/devicetree/bindings/display/bridge/toshiba,tc358775.yaml b/Documentation/devicetree/bindings/display/bridge/toshiba,tc358775.yaml --- a/Documentation/devicetree/bindings/display/bridge/toshiba,tc358775.yaml +++ b/Documentation/devicetree/bindings/display/bridge/toshiba,tc358775.yaml @@ -68,9 +68,6 @@ properties: required: - compatible - reg - - vdd-supply - - vddio-supply - - stby-gpios - reset-gpios - ports -- 2.43.0
