Hi Shawn, > Subject: [PATCH v5 0/7] gpio: update i.MX93/8ULP and support i.MX95 GPIO maintainers has picked up patch 1-5, would you pick patch 6,7? Thanks, Peng. > > From hardware perspective: > - i.MX8ULP/93 GPIO supports two interrupts, 1st for Trustzone non-secure irq, > 2nd for Trustzone secure irq. > - i.MX8ULP/93 only has one register base > > The current linux gpio-vf610.c could work with i.MX8ULP/i.MX93, it is > because some trick did in device tree node with offset added to base: > reg = <0x2d010080 0x1000>, <0x2d010040 0x40>; But actually the register > base should be 0x2d010000. > > So i.MX8ULP/93 is not HW compatible with i.MX7ULP. > > i.MX93 GPIO is directly derived from i.MX8ULP, so make i.MX93 compatible > with i.MX8ULP. i.MX95 GPIO is same as i.MX93, so also compatible with > i.MX8ULP > > There maybe dtbs_check failure if only test the 1st patch. After the patchset > applied, no failure. > > To make avoid break old bindings from work, update the driver to support > both old/new bindings. > > --- > Changes in v5: > - Add R-b for patch 1, 2 > - Simplify code a bit more in patch 4 pPer Marco's comments > - Update patch 5 to only drop port->sdata check, since patch 4 is changed. > - Link to v4: https://lore.kernel.org/r/20230926-vf610-gpio-v4-0- > b57b7f6e8368@xxxxxxx > > Changes in v4: > Change to minItems for allOf: else: interrupts Update commit log for patch > 4/6 Follow Marco's comments for patch 4/6 Add a new patch 5/6 Per > Marco's comments. > > Changes in v3: > Update patch v2 2/6 > Update commit log in patch v2 5/6 > Add A-b from DT maintainer for patch v2 1/6, 3/6 > - Link to v2: https://lore.kernel.org/r/20230916-vf610-gpio-v2-0- > 40823da788d7@xxxxxxx > > Changes in v2: > - Update bindings with describe items, add one reg base for i.MX8ULP/93 > - Update driver to support one reg base, support both new/old bindings > - Add a new patch 1 to update gpio-ranges found in dtbs_check > - Link to v1: https://lore.kernel.org/r/20230914-vf610-gpio-v1-0- > 3ed418182a6a@xxxxxxx > > --- > Peng Fan (7): > dt-bindings: gpio: vf610: update gpio-ranges > dt-bindings: gpio: vf610: correct i.MX8ULP and i.MX93 > dt-bindings: gpio: vf610: add i.MX95 compatible > gpio: vf610: add i.MX8ULP of_device_id entry > gpio: vf610: simplify code by dropping data check > arm64: dts: imx8ulp: update gpio node > arm64: dts: imx93: update gpio node > > .../devicetree/bindings/gpio/gpio-vf610.yaml | 40 +++++++++++++--- > arch/arm64/boot/dts/freescale/imx8ulp.dtsi | 21 +++++---- > arch/arm64/boot/dts/freescale/imx93.dtsi | 28 +++++++----- > drivers/gpio/gpio-vf610.c | 53 ++++++++++++++++++---- > 4 files changed, 105 insertions(+), 37 deletions(-) > --- > base-commit: e143016b56ecb0fcda5bb6026b0a25fe55274f56 > change-id: 20230914-vf610-gpio-46edacd2b513 > > Best regards, > -- > Peng Fan <peng.fan@xxxxxxx>
