On Thu, Sep 21, 2023 at 09:21:40PM +0300, Arınç ÜNAL wrote: > On 21.09.2023 16:00, Andrew Lunn wrote: > > > - Link descriptions must be required on ethernet controllers. We don't care > > > whether some Linux driver can or cannot find the PHY or set up a fixed > > > link without looking at the devicetree. > > > > That can lead to future surprises, and breakage. > > > > Something which is not used is not tested, and so sometimes wrong, and > > nobody knows. Say the driver is extended to a new device and actually > > does need to use this never before used information. You then find it > > is wrong, and you get a regression. > > > > We have had issues like this before. There are four rgmii phy-link > > modes. We have had PHY drivers which ignored one of those modes, it > > silently accepted it, but did not change the hardware to actually use > > that mode. The PHY continues to use its reset defaults or strapping, > > and it worked. A lot of device trees ended up using this mode. And it > > was not the same as reset defaults/strapping. > > > > And then somebody needed that fourth mode, and made it actually > > work. And all those boards wrongly using that mode broke. > > > > The lesson i learned from that episode is that anything in device tree > > must actually be used and tested. > > It looks like the root cause here was the lack of dt-bindings to > only allow the phy-mode values the hardware supports. That would not help. The hardware supported all 4 RGMII modes. So listing all four in the dt-binding would be correct. But the driver for the hardware had a bug, and so silently ignored one of the modes. That then masked the bugs in board DT files. > What I see here is the driver change should've been tested on all > different hardware the driver controls then the improper describing > of hardware on the devicetree source file addressed. Which is what did happen. But it took a while to find all those broken boards. For a period of time, we had regressions. Bugs happen. It is a fact of life. But we want those bugs to be easy to find as possible. If we force DT writers to add properties which the driver never uses, they are going to be bugs in those properties. And those bugs are not going to be easy to find, and quite likely, they will only be found a long time after they are added. We should not be adding unused properties and bugs just to keep a yaml checker happy. Andrew