> - Link descriptions must be required on ethernet controllers. We don't care > whether some Linux driver can or cannot find the PHY or set up a fixed > link without looking at the devicetree. That can lead to future surprises, and breakage. Something which is not used is not tested, and so sometimes wrong, and nobody knows. Say the driver is extended to a new device and actually does need to use this never before used information. You then find it is wrong, and you get a regression. We have had issues like this before. There are four rgmii phy-link modes. We have had PHY drivers which ignored one of those modes, it silently accepted it, but did not change the hardware to actually use that mode. The PHY continues to use its reset defaults or strapping, and it worked. A lot of device trees ended up using this mode. And it was not the same as reset defaults/strapping. And then somebody needed that fourth mode, and made it actually work. And all those boards wrongly using that mode broke. The lesson i learned from that episode is that anything in device tree must actually be used and tested. > Although I see dsa.yaml and dsa-port.yaml mostly consist of describing an > ethernet switch with CPU port(s), there're properties that are specific to > DSA, such as dsa,member on dsa.yaml and dsa-tag-protocol and label on > dsa-port.yaml. I would say dsa,member does describe the hardware. It provides two bits of information: Which cluster of switches does this switch belong to. You probably can derive it using the DSA links between switches, which is also a hardware property. But having it in device tree makes it simpler. Which switch is this within a cluster. You need to be able to say: Send this frame out Port X of switch Y. How does a switch know it is Y? It could be strapping, which is clearly a hardware property. dsa-tag-protocol is similar to phy-mode. It tells you the protocol running between the CPU port and the SoC master interface. You often can imply it, but again, it could be determined by strapping on the switch. label is an interesting one, and probably would not be accepted if it was proposed now. But it has been around a long time. It also does describe the hardware, it is what is printed on the case next to the RJ45. To make the user experience simpler, we then try to make the linux interface name match the label on the case. Andrew
