From: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx> The NXP-specific "irda-mode-ports" property lacks a proper vendor prefix. Add "nxp," prefix to comply with DT best practises. Signed-off-by: Hugo Villeneuve <hvilleneuve@xxxxxxxxxxxx> --- .../devicetree/bindings/serial/nxp,sc16is7xx.txt | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt index 1a7e4bff0456..d89815c5c562 100644 --- a/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt +++ b/Documentation/devicetree/bindings/serial/nxp,sc16is7xx.txt @@ -21,8 +21,8 @@ Optional properties: the second cell is used to specify the GPIO polarity: 0 = active high, 1 = active low. -- irda-mode-ports: An array that lists the indices of the port that - should operate in IrDA mode. +- nxp,irda-mode-ports: An array that lists the indices of the port that + should operate in IrDA mode. - nxp,modem-control-line-ports: An array that lists the indices of the port that should have shared GPIO lines configured as modem control lines. @@ -80,8 +80,8 @@ Optional properties: the second cell is used to specify the GPIO polarity: 0 = active high, 1 = active low. -- irda-mode-ports: An array that lists the indices of the port that - should operate in IrDA mode. +- nxp,irda-mode-ports: An array that lists the indices of the port that + should operate in IrDA mode. - nxp,modem-control-line-ports: An array that lists the indices of the port that should have shared GPIO lines configured as modem control lines. -- 2.30.2