In order to support half-duplex operation at 10M and 100M link speeds, the
PHY collision detection signal (COL) should be routed to ICSSG
GPIO pin (PRGx_PRU0/1_GPI10) so that firmware can detect collision signal
and apply the CSMA/CD algorithm applicable for half duplex operation. A DT
property, "ti,half-duplex-capable" is introduced for this purpose. If
board has PHY COL pin conencted to PRGx_PRU1_GPIO10, this DT property can
be added to eth node of ICSSG, MII port to support half duplex operation at
that port.
Reviewed-by: Roger Quadros <rogerq@xxxxxxxxxx>
Signed-off-by: MD Danish Anwar <danishanwar@xxxxxx>
---
Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml b/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
index 836d2d60e87d..229c8f32019f 100644
--- a/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
+++ b/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml
@@ -107,6 +107,13 @@ properties:
phandle to system controller node and register offset
to ICSSG control register for RGMII transmit delay
+ ti,half-duplex-capable:
+ type: boolean
+ description:
+ Indicates that the PHY output pin COL is routed to ICSSG GPIO pin
+ (PRGx_PRU0/1_GPIO10) as input so that the ICSSG MII port is
+ capable of half duplex operations.
+
required:
- reg
anyOf:
--
2.34.1
