On Thu, 24 Aug 2023 13:10:14 +0200, Martin Zaťovič wrote: > GPIO bitbanged Wiegand controller requires definitions of GPIO lines to be > used on top of the common Wiegand properties. Wiegand utilizes two such > lines - DATA0(low data line) and DATA1(high data line). > > Acked-by: Linus Walleij <linus.walleij@xxxxxxxxxx> > Signed-off-by: Martin Zaťovič <m.zatovic1@xxxxxxxxx> > --- > .../bindings/wiegand/wiegand-gpio.yaml | 46 +++++++++++++++++++ > MAINTAINERS | 5 ++ > 2 files changed, 51 insertions(+) > create mode 100644 Documentation/devicetree/bindings/wiegand/wiegand-gpio.yaml > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: Documentation/devicetree/bindings/wiegand/wiegand-gpio.example.dts:20.21-29.11: Warning (unit_address_vs_reg): /example-0/wiegand@f00: node has a unit name, but no reg or ranges property doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230824111015.57765-4-m.zatovic1@xxxxxxxxx The base for the series is generally the latest rc1. A different dependency should be noted in *this* patch. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit after running the above command yourself. Note that DT_SCHEMA_FILES can be set to your schema file to speed up checking your schema. However, it must be unset to test all examples with your schema.