Dne ponedeljek, 21. avgust 2023 ob 16:03:47 CEST je Martin Botka napisal(a):
> Add support for the thermal sensor found in H616 SoC
> which slightly resembles the H6 thermal sensor
> controller with few changes like 4 sensors.
>
> Signed-off-by: Martin Botka <martin.botka@xxxxxxxxxxxxxx>
> ---
> drivers/thermal/sun8i_thermal.c | 74
> +++++++++++++++++++++++++++++++++++++++++ 1 file changed, 74 insertions(+)
>
> diff --git a/drivers/thermal/sun8i_thermal.c
> b/drivers/thermal/sun8i_thermal.c index 195f3c5d0b38..cf96ab6a445b 100644
> --- a/drivers/thermal/sun8i_thermal.c
> +++ b/drivers/thermal/sun8i_thermal.c
> @@ -278,6 +278,66 @@ static int sun50i_h6_ths_calibrate(struct ths_device
> *tmdev, return 0;
> }
>
> +static int sun50i_h616_ths_calibrate(struct ths_device *tmdev,
> + u16 *caldata, int callen)
> +{
> + struct device *dev = tmdev->dev;
> + int i, ft_temp;
> +
> + if (!caldata[0])
> + return -EINVAL;
> +
> + /*
> + * h616 efuse THS calibration data layout:
> + *
> + * 0 11 16 27 32 43 48 57
> + * +----------+-----------+-----------+-----------+
> + * | temp | |sensor0| |sensor1| |sensor2| |
> + * +----------+-----------+-----------+-----------+
> + * ^ ^ ^
> + * | | |
> + * | | sensor3[11:8]
> + * | sensor3[7:4]
> + * sensor3[3:0]
> + *
> + * The calibration data on the H616 is the ambient temperature and
> + * sensor values that are filled during the factory test stage.
> + *
> + * The unit of stored FT temperature is 0.1 degree celsius.
> + */
> + ft_temp = caldata[0] & FT_TEMP_MASK;
> +
> + for (i = 0; i < tmdev->chip->sensor_num; i++) {
> + int delta, cdata, offset, reg;
> +
> + if (i == 3)
> + reg = (caldata[1] >> 12)
> + | ((caldata[2] >> 12) << 4)
> + | ((caldata[3] >> 12) << 8);
> + else
> + reg = (int)caldata[i + 1] & TEMP_CALIB_MASK;
> +
> + int sensor_temp = tmdev->chip->calc_temp(tmdev, i, reg);
Variable declaration should be done at the beginning of code block.
Best regards,
Jernej
> +
> + delta = (sensor_temp - ft_temp * 100) * 10;
> + delta /= tmdev->chip->scale;
> + cdata = CALIBRATE_DEFAULT - delta;
> + if (cdata & ~TEMP_CALIB_MASK) {
> + dev_warn(dev, "sensor%d is not calibrated.
\n", i);
> +
> + continue;
> + }
> +
> + offset = (i % 2) * 16;
> + regmap_update_bits(tmdev->regmap,
> + SUN50I_H6_THS_TEMP_CALIB + (i /
2 * 4),
> + TEMP_CALIB_MASK << offset,
> + cdata << offset);
> + }
> +
> + return 0;
> +}
> +
> static int sun8i_ths_calibrate(struct ths_device *tmdev)
> {
> struct nvmem_cell *calcell;
> @@ -608,6 +668,19 @@ static const struct ths_thermal_chip sun50i_h6_ths = {
> .calc_temp = sun8i_ths_calc_temp,
> };
>
> +static const struct ths_thermal_chip sun50i_h616_ths = {
> + .sensor_num = 4,
> + .has_bus_clk_reset = true,
> + .ft_deviation = 8000,
> + .offset = 263655,
> + .scale = 810,
> + .temp_data_base = SUN50I_H6_THS_TEMP_DATA,
> + .calibrate = sun50i_h616_ths_calibrate,
> + .init = sun50i_h6_thermal_init,
> + .irq_ack = sun50i_h6_irq_ack,
> + .calc_temp = sun8i_ths_calc_temp,
> +};
> +
> static const struct of_device_id of_ths_match[] = {
> { .compatible = "allwinner,sun8i-a83t-ths", .data =
&sun8i_a83t_ths },
> { .compatible = "allwinner,sun8i-h3-ths", .data = &sun8i_h3_ths },
> @@ -616,6 +689,7 @@ static const struct of_device_id of_ths_match[] = {
> { .compatible = "allwinner,sun50i-a100-ths", .data =
&sun50i_a100_ths },
> { .compatible = "allwinner,sun50i-h5-ths", .data = &sun50i_h5_ths
},
> { .compatible = "allwinner,sun50i-h6-ths", .data = &sun50i_h6_ths
},
> + { .compatible = "allwinner,sun50i-h616-ths", .data =
&sun50i_h616_ths },
> { /* sentinel */ },
> };
> MODULE_DEVICE_TABLE(of, of_ths_match);
