From: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
Add a second SGMII PHY that will be used by EMAC1 on sa8775p-ride.
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@xxxxxxxxxx>
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sa8775p-ride.dts | 9 +++++++++
1 file changed, 9 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
index f9e1a017798e..486cb48ecb9d 100644
--- a/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
+++ b/arch/arm64/boot/dts/qcom/sa8775p-ride.dts
@@ -287,6 +287,15 @@ sgmii_phy0: phy@8 {
reset-assert-us = <11000>;
reset-deassert-us = <70000>;
};
+
+ sgmii_phy1: phy@a {
+ compatible = "ethernet-phy-id0141.0dd4";
+ reg = <0xa>;
+ device_type = "ethernet-phy";
+ reset-gpios = <&pmm8654au_2_gpios 9 GPIO_ACTIVE_LOW>;
+ reset-assert-us = <11000>;
+ reset-deassert-us = <70000>;
+ };
};
mtl_rx_setup: rx-queues-config {
--
2.39.2
