On 9.08.2023 14:04, Bryan O'Donoghue wrote:
> There are two control lines controlled by GPIO going into ov5640
>
> - Reset
> - Powerdown
>
> The driver and yaml expect "reset-gpios" and "powerdown-gpios" there has
> never been an "enable-gpios".
>
> Fixes: 39e0ce6cd1bf ("arm64: dts: qcom: apq8016-sbc: Add CCI/Sensor nodes")
> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
> ---
Assuming that the polarity is still correct (maybe the og commiter had
different assumptions about what this pin did):
Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxx>
Konrad
