On 8/8/23 12:27 AM, Jan Kiszka wrote:
On 07.08.23 17:18, Andrew Davis wrote:
On 8/7/23 1:16 AM, Dhruva Gole wrote:
Hi Andrew,
On 03/08/23 02:23, Andrew Davis wrote:
OSPI nodes defined in the top-level AM65x SoC dtsi files are incomplete
and may not be functional unless they are extended with pinmux and
device information.
As the attached OSPI device is only known about at the board integration
level, these nodes should only be enabled when provided with this
information.
Disable the OSPI nodes in the dtsi files and only enable the ones that
are actually pinned out on a given board.
Signed-off-by: Andrew Davis <afd@xxxxxx>
---
arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi | 1 +
arch/arm64/boot/dts/ti/k3-am65-mcu.dtsi | 2 ++
arch/arm64/boot/dts/ti/k3-am654-base-board.dts | 1 +
3 files changed, 4 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi
b/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi
index e26bd988e5224..6041862d5aa75 100644
--- a/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am65-iot2050-common.dtsi
@@ -593,6 +593,7 @@ adc {
};
&ospi0 {
+ status = "okay";
Ok, so this k3-am65-iot2050 series of DT files seem to be structured in
a bit different manner than our SKs and EVMs?
The terminologies like advanced, advanced-m2, basic, etc. are a little
confusing to me. However, I am wondering if we don't do any status = ..
here, and rather make ospi status okays from the iot2050 dts files?
Pardon me if I am making an invalid suggestion, I don't have much
background on these boards.
This is a valid question, and yes the IOT2050 DTS organization is
slightly different than the one we use with our SK/EVMs.
The way these DT files tend to work is layering more functionality
or information in each file, starting with the core/most common
in the base .dtsi, and ending with .dts that is specific to a given
board. (In that way I would consider instances of "/delete-node/"
to be an indicator of bad layering, but that is a different topic..)
Any node that is only partially defined in a layer should be marked
disabled, and then only enabled in the layer that finally completes
the node. That is often the pinmux info at the board level.
In this case, the OSPI nodes are complete after this point, there
is no additional information given in the DTS files, so we can
enable it here in this .dtsi file.
Ack, this file is the right place to enable OSPI because all our boards
have OSPI in use, and therefore it is configured at this common level
already.
And the reasons for delete-node is obviously that there is no dtsi file
that describes the AM6528 with its two cores only. If you consider that
bad layering, you should change your dtsi files ;). But I see no real
problem here, that pattern is not uncommon.
Yup, wasn't finger pointing, that is our layering problem. It actually
looks like an easy fix to add an k3-am652.dtsi with only two cores, I'll
go do that for next cycle.
Andrew
Jan