On Mon, Jul 31, 2023 at 11:23:28AM +0200, Alexander Stein wrote: > Hi, > > thanks everyone for the feedback. This is the fifth round of this series to > add support for the TQMLS1021A using the MBLS1021A mainboard. > Removing the 'dma-coherent' property was a workaround carried on from older > downstream kernels and is not necessary anymore. > The same goes for adjusting the size for 'scfg' node. Removing this also > fixes the node label ordering. > > Changes in v5: > * Add newline for include header grouping > * Put status property at the end of properties (lpuart0) > * Do not remove 'dma-coherent' for sata > * Do not adjust 'reg' property for 'scfg' > > Changes in v4: > * Dropped display overlay for now as DCU patch is still pending > * Rebase to next-20230721 > * Move status property to last position > * Rename stmpe811 node name > * Remove superfluous #address-cells and #size-cells for stmpe811 > * Add missing interrupt-controller properties for stmpe811 > * Remove superfluous ESDHCI compatible overwrite in SoM .dtsi > > Best regards, > Alexander > > Alexander Stein (2): > ARM: dts: ls1021a: add TQ-Systems MBLS102xA device tree > ARM: dts: ls1021a: add TQMLS1021A flash partition layout > > Matthias Schiffer (1): > dt-bindings: arm: fsl: add TQ-Systems LS1021A board Applied all, thanks!
