-------- 原始信息 -------- 主题: Re: [PATCH v1 0/2] Add ethernet nodes for StarFive JH7110 SoC From: Conor Dooley <conor@xxxxxxxxxx> 收件人: Conor Dooley <conor@xxxxxxxxxx>, Rob Herring <robh+dt@xxxxxxxxxx>, Krzysztof Kozlowski <krzysztof.kozlowski+dt@xxxxxxxxxx>, Paul Walmsley <paul.walmsley@xxxxxxxxxx>, Palmer Dabbelt <palmer@xxxxxxxxxxx>, Albert Ou <aou@xxxxxxxxxxxxxxxxx>, Hal Feng <hal.feng@xxxxxxxxxxxxxxxx>, linux-kernel@xxxxxxxxxxxxxxx, linux-riscv@xxxxxxxxxxxxxxxxxxx, devicetree@xxxxxxxxxxxxxxx, netdev@xxxxxxxxxxxxxxx, Samin Guo <samin.guo@xxxxxxxxxxxxxxxx> 日期: 2023/7/21 > From: Conor Dooley <conor.dooley@xxxxxxxxxxxxx> > > On Fri, 14 Jul 2023 18:45:19 +0800, Samin Guo wrote: >> This series adds ethernet nodes for StarFive JH7110 RISC-V SoC, >> and has been tested on StarFive VisionFive-2 v1.2A and v1.3B SBC boards. >> >> The first patch adds ethernet nodes for jh7110 SoC, the second patch >> adds ethernet nodes for visionfive 2 SBCs. >> >> This series relies on xingyu's syscon patch[1]. >> For more information and support, you can visit RVspace wiki[2]. >> >> [...] > > Applied to riscv-dt-for-next, thanks! > > [1/2] riscv: dts: starfive: jh7110: Add ethernet device nodes > https://git.kernel.org/conor/c/1ff166c97972 > [2/2] riscv: dts: starfive: visionfive 2: Add configuration of gmac and phy > https://git.kernel.org/conor/c/b15a73c358d1 > > Thanks, > Conor. Hi Conor， Thank you so much！ There is a question about the configuration of phy that I would like to consult you. Latest on motorcomm PHY V5[1]: Follow Rob Herring's advice motorcomm,rx-xxx-driver-strength Changed to motorcomm,rx-xxx-drv-microamp . V5 has already received a reviewed-by from Andrew Lunn, and it should not change again. Should I submit another pacthes based on riscv-dt-for-next? [1] https://patchwork.kernel.org/project/netdevbpf/cover/20230720111509.21843-1-samin.guo@xxxxxxxxxxxxxxxx Best regards, Samin
