On Thu, Jul 13, 2023 at 11:21:23PM +0300, Alexandru Ardelean wrote: > For VSC8351 and similar PHYs, a new property was added to generate a clock > signal on the CLKOUT pin. Sorry, didn't think about it on v1, but I would imagine other vendors' PHYs have similar functionality. We should have something common. We have the clock binding for clocks already, so we should consider if that should be used here. It may look like an overkill for what you need, but things always start out that way. What if you want to turn the clock on and off as well? > This change documents the change in the device-tree bindings doc. That's obvious. > > Signed-off-by: Alexandru Ardelean <alex@xxxxxxxxxxx> > --- > > Changelog v1 -> v2: > * https://lore.kernel.org/netdev/20230706081554.1616839-2-alex@xxxxxxxxxxx/ > * changed property name 'vsc8531,clkout-freq-mhz' -> 'mscc,clkout-freq-mhz' > as requested by Rob > * added 'net-next' tag as requested by Andrew > > Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt | 5 +++++ > 1 file changed, 5 insertions(+) > > diff --git a/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt b/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt > index 0a3647fe331b..085d0e8a834e 100644 > --- a/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt > +++ b/Documentation/devicetree/bindings/net/mscc-phy-vsc8531.txt > @@ -31,6 +31,10 @@ Optional properties: > VSC8531_LINK_100_ACTIVITY (2), > VSC8531_LINK_ACTIVITY (0) and > VSC8531_DUPLEX_COLLISION (8). > +- mscc,clkout-freq-mhz : For VSC8531 and similar PHYs, this will output > + a clock signal on the CLKOUT pin of the chip. > + The supported values are 25, 50 & 125 Mhz. > + Default value is no clock signal on the CLKOUT pin. > - load-save-gpios : GPIO used for the load/save operation of the PTP > hardware clock (PHC). > > @@ -69,5 +73,6 @@ Example: > vsc8531,edge-slowdown = <7>; > vsc8531,led-0-mode = <VSC8531_LINK_1000_ACTIVITY>; > vsc8531,led-1-mode = <VSC8531_LINK_100_ACTIVITY>; > + mscc,clkout-freq-mhz = <50>; > load-save-gpios = <&gpio 10 GPIO_ACTIVE_HIGH>; > }; > -- > 2.41.0 >
