On 5. 07. 23 14:06, Ahmad Fatoum wrote:
On 05.07.23 12:39, Andrej Picej wrote:> On 5. 07. 23 10:40, Andrej Picej wrote:
On 5. 07. 23 10:30, Ahmad Fatoum wrote:
On 05.07.23 10:28, Andrej Picej wrote:
I think the main reason for a failed boot is that the PMIC doesn't get reset and that the bootloader doesn't specifically enable the SD card regulator.
Could this patch still be applied or should we put the fix in reset routine/bootloader?
Is SD-Card not main boot medium? From your description, I thought BootROM
will fail to boot before bootloader has a chance to do anything about it.
Yes sorry, you are absolutly right, the BootROM fails. It confused me because I could see the booloader booting, but it was from one of the fallback mediums. So I guess fixing the bootloader is not really an option.
Sorry for the confusion.
Ok, the main problem is well known, that's why PHYTEC disables the imx watchdog and uses a PMIC one for the reboot handler. This one resets the board completely. The SD card regulator problem is really just the manifestation of that bug. Unfortunately I didn't noticed that. :(
I will create a v2 with a proper fix, where imx watchdog gets disabled.
I'd be wary about solving it this way at the DTSI level, because it can
break existing users:
- Boot flow depends on reading boot reason, but with PMIC reset, everything
is power-on reset
- Bootloader starts i.MX watchdog, but new kernel will service only
PMIC watchdog leading to system reset
- Even if updating bootloader and kernel together, fallback of kernel
may end up that bootloader uses PMIC watchdog, but kernel uses i.MX
watchdog
- There can be valid reasons to use both watchdogs and disabling
one at the SoM level breaks that
> I had a similar issue once (Board controller reset to be used instead
of SoC
reset) and settled on using the barebox watchdog-priority/restart-priority[1]
binding to select the "better" watchdog and then fixed up this choice into
the kernel command line (barebox CONFIG_SYSTEMD_OF_WATCHDOG).
If you decide to fix it for the evaluation kits, please add some text
into the commit message that this fix should not be backported to older kernels.
While it's ultimately the correct thing to do, changing this is IMO not stable
backport material.
[1]: FWIW, there was past discussion about adding restart priorities to Linux, e.g.
https://lore.kernel.org/all/20201006102949.dbw6b2mrgt2ltgpw@xxxxxxxxxxxxxx/
Ok I see the problems this might raise. Nevertheless I think it would be
good to sync upstream and PHYTEC downstream dts with this fix. Since by
default imx watchdog reset is really a no-go with phyFLEX.
We could add the aliases for the watchdogs, marking the PMIC watchdog as
watchdog0, and imx watchdog as watchdog1 which I think should tell the
kernel to use the PMIC reboot handler, but not really sure how is that
any better then disabling the imx watchdog.
Why do you think this shouldn't be backported to older kernels? Because
someone might use this with "not compatible" bootloader?
Thanks for your help,
Andrej
Cheers,
Ahmad
Thanks for your help,
Andrej
Best regards,
Andrej
Regards,
Marco
};
vdd_sd1_reg: ldo10 {
--
2.25.1
